Re: [PATCH] mtd: rawnand: qcom: Rename parameter name in macro

[Miquel Raynal <miquel.raynal@bootlin.com>]

Hello,

Md Sadre Alam <mdalam@codeaurora.org> wrote on Mon, 22 Feb 2021
13:05:42 +0530:

> This change will rename parameter name in macro
> nandc_set_read_loc().renamed parameter names are
> cw_offset, read_size, is_last_read_loc.
> Sinc in QPIC V2 on-wards there is separate location
> register to read last code word, so to just differnciate
> b/w is_last_read_loc from last_cw this change needed.

"
Rename the parameters of the nandc_set_read_loc() macro to avoid the
confusion between is_last_read_loc which <explain what it is> and
<last_cw> which <explain what it is as well>.

> 
> Signed-off-by: Md Sadre Alam <mdalam@codeaurora.org>
> ---
>  drivers/mtd/nand/raw/qcom_nandc.c | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
> index 4189a7f..bfefb4e 100644
> --- a/drivers/mtd/nand/raw/qcom_nandc.c
> +++ b/drivers/mtd/nand/raw/qcom_nandc.c
> @@ -181,11 +181,11 @@
>  #define	ECC_BCH_4BIT	BIT(2)
>  #define	ECC_BCH_8BIT	BIT(3)
>  
> -#define nandc_set_read_loc(nandc, reg, offset, size, is_last)	\
> +#define nandc_set_read_loc(nandc, reg, cw_offset, read_size, is_last_read_loc)	\
>  nandc_set_reg(nandc, NAND_READ_LOCATION_##reg,			\
> -	      ((offset) << READ_LOCATION_OFFSET) |		\
> -	      ((size) << READ_LOCATION_SIZE) |			\
> -	      ((is_last) << READ_LOCATION_LAST))
> +	      ((cw_offset) << READ_LOCATION_OFFSET) |		\
> +	      ((read_size) << READ_LOCATION_SIZE) |			\
> +	      ((is_last_read_loc) << READ_LOCATION_LAST))
>  
>  /*
>   * Returns the actual register address for all NAND_DEV_ registers

Thanks,
Miquèl