Re: [PATCH] usb: storage: realtek_cr: get lock before calling usb_enable_autosuspend()

Alan Stern
2021-08-03T00:56:36Z

On Tue, Aug 03, 2021 at 12:03:13AM +0100, Salah Triki wrote:
> Based on the documentation of usb_enable_autosuspend(), the
> caller must hold udev's device lock.
>
> Signed-off-by: Salah Triki <salah.triki@gmail.com>
> ---
> drivers/usb/storage/realtek_cr.c | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/drivers/usb/storage/realtek_cr.c b/drivers/usb/storage/realtek_cr.c
> index 3789698d9d3c..6948d6fdad39 100644
> --- a/drivers/usb/storage/realtek_cr.c
> +++ b/drivers/usb/storage/realtek_cr.c
> @@ -918,9 +918,13 @@ static int realtek_cr_autosuspend_setup(struct us_data *us)
> timer_setup(&chip->rts51x_suspend_timer, rts51x_suspend_timer_fn, 0);
> fw5895_init(us);
>
> + usb_lock_device(us->pusb_dev);
> +
> /* enable autosuspend function of the usb device */
> usb_enable_autosuspend(us->pusb_dev);
>
> + usb_unlock_device(us->pusb_dev);
> +
> return 0;
> }
> #endif

I assume you didn't test this patch, because RTS51xx card readers aren't
very common. If you had tested it, you would have found that it causes
the system to hang.

This is because when realtek_cr_autosuspend_setup runs, the driver
already holds the device lock. The route is a little circuitous:

realtek_cr_probe is called with the lock held, like all
probe routines.

It calls usb_store_probe2, which calls
usb_stor_acquire_resources. That routine calls
us->unusual_dev->initFunction. For the realtek_cr driver, the
initFunction is set to init_realtek_cr (see unusual_realtek.h).

init_realtek_cr calls realtek_cr_autosuspend_setup.

There is no other pathway to the usb_enable_autosuspend call. So your
patch is not needed.

Alan Stern