Re: [PATCH v2 6/7] tracing/user_events: Use bits vs bytes for enabled status page data

[Beau Belgrave <beaub@linux.microsoft.com>]

On Wed, Jul 27, 2022 at 09:45:17AM -0400, Steven Rostedt wrote:
> On Tue, 26 Jul 2022 19:01:47 -0700
> Beau Belgrave <beaub@linux.microsoft.com> wrote:
> 
> > Ah, I see the confusion. Sorry.  
> > 
> > EVENT_STATUS_* are internal bits that aren't used with STATUS_MASK or
> > STATUS_BYTE. It's only used to set and check the user event status byte
> > for checking if anything is attached and outputting which probe is
> > connected within the kernel side.
> > 
> > STATUS_BYTE and STATUS_MASK take a bit in a bitmap and figure out which
> > byte in the status mapping should be used and which bit in that byte
> > should be set/reset (mask) when it's enabled/disabled via a probe. Both
> > the user and kernel need to align on this logic.
> > 
> > IE: Bits above the lower 3 of the index/bit of the event to enable is the byte
> > and the lower 3 bits (& 7) is the actual bit to set.
> > 
> > For example if the user_event with the index 1024 is enabled, we need to
> > figure out which byte and bit represents that event when a probe is
> > attached.
> > 
> > I got into detail of this in the documentation for both a byte and long
> > wise checking of these values.
> > 
> > Hope that helps explain it.
> 
> Yes, but that should be in the comments above the code.
> 

Will do, I will also change to use the BIT() macro as you suggested.

> -- Steve

Thanks,
-Beau