[PATCH] pinctrl: rockchip: Enhance support for IRQ_TYPE_EDGE_BOTH

João H. Spies
2022-08-08T02:53:33Z

Switching between falling/rising edges for IRQ_TYPE_EDGE_BOTH on pins that
require debounce can cause the device to lose events due to a desync
between pin state and irq type.

This problem is resolved by switching between IRQ_TYPE_LEVEL_LOW and
IRQ_TYPE_LEVEL_HIGH instead.

Fixes: 936ee26 ("gpio/rockchip: add driver for rockchip gpio")
Signed-off-by: João H. Spies <jhlspies@gmail.com>
---
drivers/gpio/gpio-rockchip.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-rockchip.c b/drivers/gpio/gpio-rockchip.c
index 099e358d2491..48b948723077 100644
--- a/drivers/gpio/gpio-rockchip.c
+++ b/drivers/gpio/gpio-rockchip.c
@@ -417,11 +417,11 @@ static int rockchip_irq_set_type(struct irq_data *d, unsigned int type)
goto out;
} else {
bank->toggle_edge_mode |= mask;
- level |= mask;
+ level &= ~mask;

/*
* Determine gpio state. If 1 next interrupt should be
- * falling otherwise rising.
+ * low otherwise high.
*/
data = readl(bank->reg_base + bank->gpio_regs->ext_port);
if (data & mask)
--
2.30.2