Re: [PATCH v8 0/5] add imx8dxl evk support

[Shawn Guo <shawnguo@kernel.org>]

On Wed, Sep 14, 2022 at 08:58:43AM -0500, Shenwei Wang wrote:
> i.MX8DXL is a device targeting the automotive and industrial market
> segments. The chip is designed to achieve both high performance and
> low power consumption. It has a dual (2x) Cortex-A35 processor.
> 
> The series of patches is to add the imx8dxl soc and its evk board
> support.
> 
> changes in V8:
>   - change the flag of gpio phandle in reg_fec1_sel node to
>     GPIO_ACTIVE_LOW to match the hardware behavior.
> 
> changes in V7:
>   - move the fec1 reset gpio into its phy node
> 
> changes in V6:
>   - The V6 changes mainly respond to the comments from Shawn
>   - Separate the V5 patch into SoC and Board commits
>   - Remove the unnecessary properties of "max-frequency"
>     in usdhc2 node
>   - Remove the unnecessary properties of "clk_csr" in eqos node
>   - Fix several coding style problems
> 
> changes in V5:
>   - change the "scu" node name to "system-controller"
>   - fix the typo in the comments for imx8dxl evk board
> 
> changes in V4:
>   - move i2c/mmc/serial aliases from soc to board
>   - correct the node names to follow the generic names recommendation
>   - remove some unused nodes in the evk board dts
> 
> changes in V3:
>   - re-order the commit sequence according to Krzysztof's feedback
>   - correct the syntax and styple problems pointed by Krzysztof
>     (Thank you for the detailed review, Krzysztof!)
>   - remove the unused nodes in imx8dxl-evk.dts
>   - dt_binding_check passed
> 
> Changes in V2:
>   - removed the edma2 device node because the edma v3 driver hasn't been
>     upstreamed yet.
>   - removed the imx8dxl_cm4 alias to fix the compile error.
>   - removed the extra blank lines at EOF.
>   - dt_binding_check passed.
> 
> Shenwei Wang (5):
>   dt-bindings: firmware: add missing resource IDs for imx8dxl
>   dt-bindings: arm: imx: update fsl.yaml for imx8dxl
>   arm64: dts: imx8: add a node label to ddr-pmu
>   arm64: dts: freescale: add i.MX8DXL SoC support
>   arm64: dts: freescale: add support for i.MX8DXL EVK board

Applied all, thanks!