Re: [PATCH 08/12] dt-bindings: pinctrl: qcom,sm8250-lpass-lpi: add bias-bus-hold and input-enable

Krzysztof Kozlowski
2022-09-23T09:32:22Z

On Thu, 22 Sep 2022 21:56:47 +0200, Krzysztof Kozlowski wrote:
> The existing SC7280 LPASS pin controller nodes use bias-bus-hold and
> input-enable, so allow them. Squash also blank lines for readability.
>
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> ---
> .../bindings/pinctrl/qcom,sm8250-lpass-lpi-pinctrl.yaml | 6 ++----
> 1 file changed, 2 insertions(+), 4 deletions(-)
>

Running 'make dtbs_check' with the schema in this patch gives the
following warnings. Consider if they are expected or the schema is
incorrect. These may not be new warnings.

Note that it is not yet a requirement to have 0 warnings for dtbs_check.
This will change in the future.

Full log is available here: https://patchwork.ozlabs.org/patch/1681325

pinctrl@33c0000: 'dmic01-active-pins', 'dmic01-sleep-pins', 'rx_swr-active-pins', 'tx_swr-active-pins', 'tx_swr-sleep-pins', 'wsa-swr-active-pins', 'wsa-swr-sleep-pins' do not match any of the regexes: '-state$', 'pinctrl-[0-9]+'
arch/arm64/boot/dts/qcom/qrb5165-rb5.dtb
arch/arm64/boot/dts/qcom/sm8250-hdk.dtb
arch/arm64/boot/dts/qcom/sm8250-mtp.dtb
arch/arm64/boot/dts/qcom/sm8250-sony-xperia-edo-pdx203.dtb
arch/arm64/boot/dts/qcom/sm8250-sony-xperia-edo-pdx206.dtb