Re: [PATCH 5.10 46/52] net: stmmac: power up/down serdes in stmmac_open/release

[Pavel Machek <pavel@denx.de>]

[-- Attachment #1: Type: text/plain, Size: 1368 bytes --]

Hi!

> The issue is related with serdes which impacts clock.  There is
> serdes in ADLink I-Pi SMARC board ethernet controller. Please refer to
> commit b9663b7ca6ff78 ("net: stmmac: Enable SERDES power up/down sequence")
> for detial. When issue is reproduced, DMA engine clock is not ready
> because serdes is not powered up.

I don't believe you got the error handling right.

> index 27b7bb64a028..41e71a26b1ad 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> @@ -2907,6 +2907,15 @@ static int stmmac_open(struct net_device *dev)
>  		goto init_error;
>  	}
>  
> +	if (priv->plat->serdes_powerup) {
> +		ret = priv->plat->serdes_powerup(dev, priv->plat->bsp_priv);
> +		if (ret < 0) {
> +			netdev_err(priv->dev, "%s: Serdes powerup failed\n",
> +				   __func__);
> +			goto init_error;
> +		}
> +	}

Ok, so serdes is powered up here.

>  	ret = stmmac_hw_setup(dev, true);
>  	if (ret < 0) {
>  		netdev_err(priv->dev, "%s: Hw setup failed\n",

But this goes to init_error, and exits w/o powering serdes down. Error
handling needs to be fixed AFAICT.

Best regards,
								Pavel
--
    echo 'DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk'
    echo 'HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany'

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 195 bytes --]