Re: [PATCH v2 3/5] mtd: rawnand: qcom: Add support for param_page read exec_ops

[Miquel Raynal <miquel.raynal@bootlin.com>]

Hi Md,

quic_mdalam@quicinc.com wrote on Thu, 11 May 2023 19:00:15 +0530:

> This change will add exec_ops for PARAM_PAGE_READ command.
> 
> Co-developed-by: Sricharan Ramabadhran <quic_srichara@quicinc.com>
> Signed-off-by: Sricharan Ramabadhran <quic_srichara@quicinc.com>
> Signed-off-by: Md Sadre Alam <quic_mdalam@quicinc.com>
> ---
> Change in [v2]
> 
> * Missed to post Cover-letter, so posting v2 patch with cover-letter
> 
>  drivers/mtd/nand/raw/qcom_nandc.c | 91 ++++++++++++++++++++++++++++++-
>  1 file changed, 90 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
> index d2f2a8971907..8717d5086f80 100644
> --- a/drivers/mtd/nand/raw/qcom_nandc.c
> +++ b/drivers/mtd/nand/raw/qcom_nandc.c
> @@ -3086,7 +3086,96 @@ static int qcom_erase_cmd_type_exec(struct nand_chip *chip, const struct nand_su
>  
>  static int qcom_param_page_type_exec(struct nand_chip *chip,  const struct nand_subop *subop)
>  {
> -	return 0;
> +	struct qcom_nand_host *host = to_qcom_nand_host(chip);
> +	struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
> +	struct qcom_op q_op;
> +	const struct nand_op_instr *instr = NULL;
> +	unsigned int op_id = 0;
> +	unsigned int len = 0;
> +	int ret = 0;
> +
> +	qcom_parse_instructions(chip, subop, &q_op);
> +
> +	q_op.cmd_reg |= PAGE_ACC | LAST_PAGE;
> +
> +	pre_command(host, NAND_CMD_PARAM);
> +	/*
> +	 * NAND_CMD_PARAM is called before we know much about the FLASH chip
> +	 * in use. we configure the controller to perform a raw read of 512
> +	 * bytes to read onfi params

There is no guess to do, just follow what the core asks.

> +	 */
> +	if (nandc->props->qpic_v2)
> +		nandc_set_reg(chip, NAND_FLASH_CMD, q_op.cmd_reg);
> +	else
> +		nandc_set_reg(chip, NAND_FLASH_CMD, q_op.cmd_reg);

There is something wrong here.

> +
> +	nandc_set_reg(chip, NAND_ADDR0, 0);
> +	nandc_set_reg(chip, NAND_ADDR1, 0);
> +	nandc_set_reg(chip, NAND_DEV0_CFG0, 0 << CW_PER_PAGE
> +					| 512 << UD_SIZE_BYTES
> +					| 5 << NUM_ADDR_CYCLES
> +					| 0 << SPARE_SIZE_BYTES);
> +	nandc_set_reg(chip, NAND_DEV0_CFG1, 7 << NAND_RECOVERY_CYCLES
> +					| 0 << CS_ACTIVE_BSY
> +					| 17 << BAD_BLOCK_BYTE_NUM
> +					| 1 << BAD_BLOCK_IN_SPARE_AREA
> +					| 2 << WR_RD_BSY_GAP
> +					| 0 << WIDE_FLASH
> +					| 1 << DEV0_CFG1_ECC_DISABLE);
> +	if (!nandc->props->qpic_v2)
> +		nandc_set_reg(chip, NAND_EBI2_ECC_BUF_CFG, 1 << ECC_CFG_ECC_DISABLE);
> +
> +	/* configure CMD1 and VLD for ONFI param probing in QPIC v1 */
> +	if (!nandc->props->qpic_v2) {
> +		nandc_set_reg(chip, NAND_DEV_CMD_VLD,
> +			      (nandc->vld & ~READ_START_VLD));
> +		nandc_set_reg(chip, NAND_DEV_CMD1,
> +			      (nandc->cmd1 & ~(0xFF << READ_ADDR))
> +			      | NAND_CMD_PARAM << READ_ADDR);
> +	}
> +
> +	nandc_set_reg(chip, NAND_EXEC_CMD, 1);
> +
> +	if (!nandc->props->qpic_v2) {
> +		nandc_set_reg(chip, NAND_DEV_CMD1_RESTORE, nandc->cmd1);
> +		nandc_set_reg(chip, NAND_DEV_CMD_VLD_RESTORE, nandc->vld);
> +	}
> +
> +	nandc_set_read_loc(chip, 0, 0, 0, 512, 1);
> +
> +	if (!nandc->props->qpic_v2) {
> +		write_reg_dma(nandc, NAND_DEV_CMD_VLD, 1, 0);
> +		write_reg_dma(nandc, NAND_DEV_CMD1, 1, NAND_BAM_NEXT_SGL);
> +	}
> +
> +	nandc->buf_count = 512;

The length is provided by the instruction.

> +	memset(nandc->data_buffer, 0xff, nandc->buf_count);
> +
> +	config_nand_single_cw_page_read(chip, false, 0);
> +
> +	read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer,
> +		      nandc->buf_count, 0);
> +
> +	/* restore CMD1 and VLD regs */
> +	if (!nandc->props->qpic_v2) {
> +		write_reg_dma(nandc, NAND_DEV_CMD1_RESTORE, 1, 0);
> +		write_reg_dma(nandc, NAND_DEV_CMD_VLD_RESTORE, 1, NAND_BAM_NEXT_SGL);
> +	}
> +
> +	ret = submit_descs(nandc);
> +	if (ret)
> +		dev_err(nandc->dev, "failure in sbumitting param page descriptor\n");
> +
> +	free_descs(nandc);
> +
> +	ret = qcom_wait_rdy_poll(chip, q_op.rdy_timeout_ms);
> +
> +	instr = q_op.data_instr;
> +	op_id = q_op.data_instr_idx;
> +	len = nand_subop_get_data_len(subop, op_id);
> +	memcpy(instr->ctx.data.buf.in, nandc->data_buffer, len);
> +
> +	return ret;
>  }
>  
>  static int qcom_read_id_type_exec(struct nand_chip *chip, const struct nand_subop *subop)


Thanks,
Miquèl