Re: [PATCH v2 3/5] arm64: dts: ti: k3-j7200-common-proc-board: main_pmx0 clean up

Kumar, Udit
2023-06-04T04:46:47Z

Thanks

On 6/1/2023 4:15 PM, Nishanth Menon wrote:
> On 15:07-20230601, Udit Kumar wrote:
>> Add main_uart0 pin mux in board common file
> $subject is a bit misleading.. I think the intent is to mux the console
> explicitly rather than a pinmux cleanup itself.

oops, missed to changed subject of this patch after split.

Will address in v3.

>> Signed-off-by: Udit Kumar<u-kumar1@ti.com>
>> ---
>> arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts | 11 +++++++++++
>> 1 file changed, 11 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
>> index 0cc0e1dc40c5..02d2e4b36b18 100644
>> --- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
>> +++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
>> @@ -113,6 +113,15 @@ J721E_IOPAD(0xd8, PIN_INPUT_PULLUP, 0) /* (W2) I2C0_SDA */
>> >;
>> };
>>
>> + main_uart0_pins_default: main_uart0_pins_default {
>> + pinctrl-single,pins = <
>> + J721E_IOPAD(0xb0, PIN_INPUT, 0) /* (T16) UART0_RXD */
>> + J721E_IOPAD(0xb4, PIN_OUTPUT, 0) /* (T17) UART0_TXD */
>> + J721E_IOPAD(0xc0, PIN_INPUT, 2) /* (W3) SPI0_CS0.UART0_CTSn */
>> + J721E_IOPAD(0xc4, PIN_OUTPUT, 2) /* (U5) SPI0_CS1.UART0_RTSn */
>> + >;
>> + };
>> +
>> main_i2c1_pins_default: main-i2c1-pins-default {
>> pinctrl-single,pins = <
>> J721E_IOPAD(0xdc, PIN_INPUT_PULLUP, 3) /* (U3) ECAP0_IN_APWM_OUT.I2C1_SCL */
>> @@ -162,6 +171,8 @@ &main_uart0 {
>> status = "okay";
>> /* Shared with ATF on this platform */
>> power-domains = <&k3_pds 146 TI_SCI_PD_SHARED>;
>> + pinctrl-names = "default";
>> + pinctrl-0 = <&main_uart0_pins_default>;
>> };
>>
>> &main_uart1 {
>> --
>> 2.34.1
>>