[PATCH v1] iio: adc: ad7192: store indio_dev into spi driver data

[Markus Burri <markus.burri@mt.com>]

After calibration the indio_dev is used to get channel information.
Since the pointer is not stored into spi driver data, there is a kernel
null pointer dereference.
Store the indio_dev into spi driver data to fix this.
Add error check and slightly extend the debug messages.

Signed-off-by: Markus Burri <markus.burri@mt.com>
---
 drivers/iio/adc/ad7192.c | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/drivers/iio/adc/ad7192.c b/drivers/iio/adc/ad7192.c
index d71977be7..7c2ead72b 100644
--- a/drivers/iio/adc/ad7192.c
+++ b/drivers/iio/adc/ad7192.c
@@ -403,8 +403,8 @@ static int ad7192_setup(struct ad7192_state *st, struct device_node *np)
 	id &= AD7192_ID_MASK;
 
 	if (id != st->chip_info->chip_id)
-		dev_warn(&st->sd.spi->dev, "device ID query failed (0x%X)\n",
-			 id);
+		dev_warn(&st->sd.spi->dev, "device ID query failed (0x%X != 0x%X)\n",
+			 id, st->chip_info->chip_id);
 
 	st->mode = AD7192_MODE_SEL(AD7192_MODE_IDLE) |
 		AD7192_MODE_CLKSRC(st->clock_sel) |
@@ -998,6 +998,7 @@ static int ad7192_probe(struct spi_device *spi)
 		return -ENOMEM;
 
 	st = iio_priv(indio_dev);
+	spi_set_drvdata(spi, indio_dev);
 
 	mutex_init(&st->lock);
 
@@ -1049,7 +1050,9 @@ static int ad7192_probe(struct spi_device *spi)
 	else
 		indio_dev->info = &ad7192_info;
 
-	ad_sd_init(&st->sd, indio_dev, spi, &ad7192_sigma_delta_info);
+	ret = ad_sd_init(&st->sd, indio_dev, spi, &ad7192_sigma_delta_info);
+	if (ret)
+		return ret;
 
 	ret = devm_ad_sd_setup_buffer_and_trigger(&spi->dev, indio_dev);
 	if (ret)
@@ -1077,7 +1080,7 @@ static int ad7192_probe(struct spi_device *spi)
 		st->fclk = clk_get_rate(st->mclk);
 		if (!ad7192_valid_external_frequency(st->fclk)) {
 			dev_err(&spi->dev,
-				"External clock frequency out of bounds\n");
+				"External clock frequency out of bounds (clk:%d)\n", st->fclk);
 			return -EINVAL;
 		}
 	}
-- 
2.39.2