From: Terry Bowman <terry.bowman@amd.com>
To: <alison.schofield@intel.com>, <vishal.l.verma@intel.com>,
<ira.weiny@intel.com>, <bwidawsk@kernel.org>,
<dan.j.williams@intel.com>, <dave.jiang@intel.com>,
<Jonathan.Cameron@huawei.com>, <linux-cxl@vger.kernel.org>
Cc: <terry.bowman@amd.com>, <rrichter@amd.com>,
<linux-kernel@vger.kernel.org>, <bhelgaas@google.com>
Subject: [PATCH v7 24/27] cxl/pci: Disable root port interrupts in RCH mode
Date: Thu, 22 Jun 2023 15:55:20 -0500 [thread overview]
Message-ID: <20230622205523.85375-25-terry.bowman@amd.com> (raw)
In-Reply-To: <20230622205523.85375-1-terry.bowman@amd.com>
The RCH root port contains root command AER registers that should not be
enabled.[1] Disable these to prevent root port interrupts.
[1] CXL 3.0 - 12.2.1.1 RCH Downstream Port-detected Errors
Signed-off-by: Terry Bowman <terry.bowman@amd.com>
Signed-off-by: Robert Richter <rrichter@amd.com>
Reviewed-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
---
drivers/cxl/core/core.h | 6 ++++++
drivers/cxl/core/pci.c | 29 +++++++++++++++++++++++++++++
drivers/cxl/core/port.c | 3 +++
3 files changed, 38 insertions(+)
diff --git a/drivers/cxl/core/core.h b/drivers/cxl/core/core.h
index 87467c633123..880bac9db376 100644
--- a/drivers/cxl/core/core.h
+++ b/drivers/cxl/core/core.h
@@ -86,4 +86,10 @@ enum cxl_poison_trace_type {
CXL_POISON_TRACE_CLEAR,
};
+#ifdef CONFIG_PCIEAER_CXL
+void cxl_disable_rch_root_ints(struct cxl_dport *dport);
+#else
+static inline void cxl_disable_rch_root_ints(struct cxl_dport *dport) { };
+#endif
+
#endif /* __CXL_CORE_H__ */
diff --git a/drivers/cxl/core/pci.c b/drivers/cxl/core/pci.c
index 9e0eba5ccfc4..897830c19d1a 100644
--- a/drivers/cxl/core/pci.c
+++ b/drivers/cxl/core/pci.c
@@ -838,6 +838,35 @@ static void cxl_handle_rdport_errors(struct cxl_dev_state *cxlds)
cxl_handle_rdport_ras(cxlds, dport);
}
+void cxl_disable_rch_root_ints(struct cxl_dport *dport)
+{
+ void __iomem *aer_base = dport->regs.dport_aer;
+ struct pci_host_bridge *bridge;
+ u32 aer_cmd_mask, aer_cmd;
+
+ if (!aer_base)
+ return;
+
+ bridge = to_pci_host_bridge(dport->dport_dev);
+
+ /*
+ * Disable RCH root port command interrupts.
+ * CXL 3.0 12.2.1.1 - RCH Downstream Port-detected Errors
+ *
+ * This sequence may not be necessary. CXL spec states disabling
+ * the root cmd register's interrupts is required. But, PCI spec
+ * shows these are disabled by default on reset.
+ */
+ if (bridge->native_cxl_error) {
+ aer_cmd_mask = (PCI_ERR_ROOT_CMD_COR_EN |
+ PCI_ERR_ROOT_CMD_NONFATAL_EN |
+ PCI_ERR_ROOT_CMD_FATAL_EN);
+ aer_cmd = readl(aer_base + PCI_ERR_ROOT_COMMAND);
+ aer_cmd &= ~aer_cmd_mask;
+ writel(aer_cmd, aer_base + PCI_ERR_ROOT_COMMAND);
+ }
+}
+
#else
static void cxl_handle_rdport_errors(struct cxl_dev_state *cxlds) { }
#endif
diff --git a/drivers/cxl/core/port.c b/drivers/cxl/core/port.c
index a92794e6b7b4..2fdfb31f16c1 100644
--- a/drivers/cxl/core/port.c
+++ b/drivers/cxl/core/port.c
@@ -1037,6 +1037,9 @@ __devm_cxl_add_dport(struct cxl_port *port, struct device *dport_dev,
cxl_dport_map_regs(dport);
+ if (dport->rch)
+ cxl_disable_rch_root_ints(dport);
+
cond_cxl_root_lock(port);
rc = add_dport(port, dport);
cond_cxl_root_unlock(port);
--
2.34.1
next prev parent reply other threads:[~2023-06-22 21:06 UTC|newest]
Thread overview: 45+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-06-22 20:54 [PATCH v7 00/27] cxl/pci: Add support for RCH RAS error handling Terry Bowman
2023-06-22 20:54 ` [PATCH v7 01/27] cxl/acpi: Probe RCRB later during RCH downstream port creation Terry Bowman
2023-06-25 19:34 ` Dan Williams
2023-06-22 20:54 ` [PATCH v7 02/27] cxl: Updates for CXL Test to work with RCH Terry Bowman
2023-06-22 20:54 ` [PATCH v7 03/27] cxl/rch: Prepare for caching the MMIO mapped PCIe AER capability Terry Bowman
2023-06-22 20:55 ` [PATCH v7 04/27] cxl: Rename member @dport of struct cxl_dport to @dport_dev Terry Bowman
2023-06-22 20:55 ` [PATCH v7 05/27] cxl: Rename 'uport' to 'uport_dev' Terry Bowman
2023-06-22 20:55 ` [PATCH v7 06/27] cxl/core/regs: Add @dev to cxl_register_map Terry Bowman
2023-06-22 20:55 ` [PATCH v7 07/27] cxl/pci: Refactor component register discovery for reuse Terry Bowman
2023-06-22 20:55 ` [PATCH v7 08/27] cxl/acpi: Move add_host_bridge_uport() after cxl_get_chbs() Terry Bowman
2023-06-22 20:55 ` [PATCH v7 09/27] cxl/acpi: Directly bind the CEDT detected CHBCR to the Host Bridge's port Terry Bowman
2023-06-22 20:55 ` [PATCH v7 10/27] cxl/port: Remove Component Register base address from struct cxl_dport Terry Bowman
2023-06-22 20:55 ` [PATCH v7 11/27] cxl/regs: Remove early capability checks in Component Register setup Terry Bowman
2023-06-22 20:55 ` [PATCH v7 12/27] cxl/mem: Prepare for early RCH dport component register setup Terry Bowman
2023-06-22 20:55 ` [PATCH v7 13/27] cxl/pci: Early setup RCH dport component registers from RCRB Terry Bowman
2023-06-22 20:55 ` [PATCH v7 14/27] cxl/port: Store the port's Component Register mappings in struct cxl_port Terry Bowman
2023-06-23 13:32 ` Jonathan Cameron
2023-06-22 20:55 ` [PATCH v7 15/27] cxl/port: Store the downstream port's Component Register mappings in struct cxl_dport Terry Bowman
2023-06-22 20:55 ` [PATCH v7 16/27] cxl/pci: Store the endpoint's Component Register mappings in struct cxl_dev_state Terry Bowman
2023-06-25 17:38 ` Dan Williams
2023-06-26 14:16 ` Terry Bowman
2023-06-30 19:51 ` Robert Richter
2023-06-30 19:56 ` Robert Richter
2023-07-03 3:55 ` Jonathan Cameron
2023-06-22 20:55 ` [PATCH v7 17/27] cxl/hdm: Use stored Component Register mappings to map HDM decoder capability Terry Bowman
2023-06-22 20:55 ` [PATCH v7 18/27] cxl/port: Remove Component Register base address from struct cxl_port Terry Bowman
2023-06-22 20:55 ` [PATCH v7 19/27] cxl/pci: Add RCH downstream port AER register discovery Terry Bowman
2023-06-22 20:55 ` [PATCH v7 20/27] PCI/AER: Refactor cper_print_aer() for use by CXL driver module Terry Bowman
2023-06-23 21:22 ` Dave Jiang
2023-06-22 20:55 ` [PATCH v7 21/27] cxl/pci: Update CXL error logging to use RAS register address Terry Bowman
2023-06-23 21:43 ` Dave Jiang
2023-06-22 20:55 ` [PATCH v7 22/27] cxl/pci: Map RCH downstream AER registers for logging protocol errors Terry Bowman
2023-06-23 21:58 ` Dave Jiang
2023-06-22 20:55 ` [PATCH v7 23/27] cxl/pci: Add RCH downstream port error logging Terry Bowman
2023-06-23 22:07 ` Dave Jiang
2023-06-22 20:55 ` Terry Bowman [this message]
2023-06-23 22:08 ` [PATCH v7 24/27] cxl/pci: Disable root port interrupts in RCH mode Dave Jiang
2023-06-22 20:55 ` [PATCH v7 25/27] PCI/AER: Forward RCH downstream port-detected errors to the CXL.mem dev handler Terry Bowman
2023-06-23 22:16 ` Dave Jiang
2023-06-25 5:47 ` Dan Williams
2023-06-22 20:55 ` [PATCH v7 26/27] PCI/AER: Unmask RCEC internal errors to enable RCH downstream port error handling Terry Bowman
2023-06-23 22:18 ` Dave Jiang
2023-06-22 20:55 ` [PATCH v7 27/27] cxl/core/regs: Rename phys_addr in cxl_map_component_regs() Terry Bowman
2023-06-23 13:30 ` Jonathan Cameron
2023-06-23 22:19 ` Dave Jiang
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20230622205523.85375-25-terry.bowman@amd.com \
--to=terry.bowman@amd.com \
--cc=Jonathan.Cameron@huawei.com \
--cc=alison.schofield@intel.com \
--cc=bhelgaas@google.com \
--cc=bwidawsk@kernel.org \
--cc=dan.j.williams@intel.com \
--cc=dave.jiang@intel.com \
--cc=ira.weiny@intel.com \
--cc=linux-cxl@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=rrichter@amd.com \
--cc=vishal.l.verma@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox