[PATCH v1 1/2] pinctrl: starfive: jh7110: Fix failure to set irq after CONFIG_PM is enabled

Hal Feng
2023-09-05T16:41:44Z

The issue was found when we enabled CONFIG_PM and tested edge events using
libgpiod.

> # gpiomon -r gpiochip0 55
> gpiomon: error waiting for events: Permission denied

`gpiomon` will call irq_chip_pm_get() and then call pm_runtime_resume_and_get()
if (IS_ENABLED(CONFIG_PM) && sfp->gc.irq.domain->pm_dev).
pm_runtime_resume_and_get() will fail if the runtime pm of pinctrl device
is disabled.

As we expect the pinctrl driver can be always working and never suspend
during runtime, unset sfp->gc.irq.domain->pm_dev to make sure
pm_runtime_resume_and_get() won't be called when setting irq.

Fixes: 447976ab62c5 ("pinctrl: starfive: Add StarFive JH7110 sys controller driver")
Signed-off-by: Hal Feng <hal.feng@starfivetech.com>
---
drivers/pinctrl/starfive/pinctrl-starfive-jh7110.c | 2 --
1 file changed, 2 deletions(-)

diff --git a/drivers/pinctrl/starfive/pinctrl-starfive-jh7110.c b/drivers/pinctrl/starfive/pinctrl-starfive-jh7110.c
index 5fe729b4a03d..72747ad497b5 100644
--- a/drivers/pinctrl/starfive/pinctrl-starfive-jh7110.c
+++ b/drivers/pinctrl/starfive/pinctrl-starfive-jh7110.c
@@ -968,8 +968,6 @@ int jh7110_pinctrl_probe(struct platform_device *pdev)
if (ret)
return dev_err_probe(dev, ret, "could not register gpiochip\n");

- irq_domain_set_pm_device(sfp->gc.irq.domain, dev);
-
dev_info(dev, "StarFive GPIO chip registered %d GPIOs\n", sfp->gc.ngpio);

return pinctrl_enable(sfp->pctl);
--
2.38.1