[PATCH v7 3/3] PCI: brcmstb: Set higher value for internal bus timeout

[Jim Quinlan <james.quinlan@broadcom.com>]

[-- Attachment #1: Type: text/plain, Size: 1726 bytes --]

During long periods of the PCIe RC HW being in an L1SS sleep state, there
may be a timeout on an internal bus access, even though there may not be
any PCIe access involved.  Such a timeout will cause a subsequent CPU
abort.

Signed-off-by: Jim Quinlan <james.quinlan@broadcom.com>
---
 drivers/pci/controller/pcie-brcmstb.c | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index f45c5d0168d3..f82a3e1a843a 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -1031,6 +1031,21 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie)
 	return 0;
 }
 
+/*
+ * This extends the timeout period for an access to an internal bus.  This
+ * access timeout may occur during L1SS sleep periods, even without the
+ * presence of a PCIe access.
+ */
+static void brcm_extend_rbus_timeout(struct brcm_pcie *pcie)
+{
+	/* TIMEOUT register is two registers before RGR1_SW_INIT_1 */
+	const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8;
+	u32 timeout_us = 4000000; /* 4 seconds, our setting for L1SS */
+
+	/* Each unit in timeout register is 1/216,000,000 seconds */
+	writel(216 * timeout_us, pcie->base + REG_OFFSET);
+}
+
 static void brcm_config_clkreq(struct brcm_pcie *pcie)
 {
 	static const char err_msg[] = "invalid 'brcm,clkreq-mode' DT string\n";
@@ -1067,6 +1082,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie)
 		 * atypical and should happen only with older devices.
 		 */
 		clkreq_cntl |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK;
+		brcm_extend_rbus_timeout(pcie);
 	} else {
 		/*
 		 * "safe" -- No power savings; refclk is driven by RC
-- 
2.17.1


[-- Attachment #2: S/MIME Cryptographic Signature --]
[-- Type: application/pkcs7-signature, Size: 4210 bytes --]