Re: [PATCH v1] PCI: Add PCIE_CONFIG_REQUEST_WAIT_MS waiting time value

[Bjorn Helgaas <helgaas@kernel.org>]

On Fri, Nov 24, 2023 at 09:45:08AM +0800, Kevin Xie wrote:
> Add the PCIE_CONFIG_REQUEST_WAIT_MS marco to define the minimum waiting
> time between sending the first configuration request to the device and
> exit from a conventional reset (or after link training completes).
> 
> As described in the conventional reset rules of PCI specifications,
> there are two different use cases of the value:
> 
>    - With a downstream port that supports link speeds <= 5.0 GT/s,
>      the waiting is following exit from a conventional reset.
> 
>    - With a downstream port that supports link speeds > 5.0 GT/s,
>      the waiting is after link training completes.
> 
> Signed-off-by: Kevin Xie <kevin.xie@starfivetech.com>
> Reviewed-by: Mason Huo <mason.huo@starfivetech.com>
> ---
>  drivers/pci/pci.h | 7 +++++++
>  1 file changed, 7 insertions(+)
> 
> diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h
> index 5ecbcf041179..4ca8766e546e 100644
> --- a/drivers/pci/pci.h
> +++ b/drivers/pci/pci.h
> @@ -22,6 +22,13 @@
>   */
>  #define PCIE_PME_TO_L2_TIMEOUT_US	10000
>  
> +/*
> + * PCIe r6.0, sec 6.6.1, <Conventional Reset>
> + * Requires a minimum waiting of 100ms before sending a configuration
> + * request to the device.
> + */
> +#define PCIE_CONFIG_REQUEST_WAIT_MS	100

Oh, and I think this name should include something about "reset"
because that's the common scenario and that's the spec section where
the value is mentioned.