Re: [PATCH V7 2/2] drm/bridge: imx: add driver for HDMI TX Parallel Video Interface

Luca Ceresoli
2024-02-02T11:27:43Z

On Sat, 6 Jan 2024 15:51:45 -0600
Adam Ford <aford173@gmail.com> wrote:

> From: Lucas Stach <l.stach@pengutronix.de>
>
> This IP block is found in the HDMI subsystem of the i.MX8MP SoC. It has a
> full timing generator and can switch between different video sources. On
> the i.MX8MP however the only supported source is the LCDIF. The block
> just needs to be powered up and told about the polarity of the video
> sync signals to act in bypass mode.
>
> Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
> Reviewed-by: Luca Ceresoli <luca.ceresoli@bootlin.com> (v2)
> Tested-by: Marek Vasut <marex@denx.de> (v1)
> Tested-by: Luca Ceresoli <luca.ceresoli@bootlin.com> (v2)
> Tested-by: Richard Leitner <richard.leitner@skidata.com> (v2)
> Tested-by: Frieder Schrempf <frieder.schrempf@kontron.de> (v2)
> Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> (v3)
> Reviewed-by: Luca Ceresoli <luca.ceresoli@bootlin.com>
> Tested-by: Luca Ceresoli <luca.ceresoli@bootlin.com>
> Tested-by: Fabio Estevam <festevam@gmail.com>
> Signed-off-by: Adam Ford <aford173@gmail.com>

On v6.8-rc1, custom hardware based on the Avnet i.MX8MP SMARC SoM.

Tested-by: Luca Ceresoli <luca.ceresoli@bootlin.com>

I think you can remove the Tested-by I sent for previous versions.

Luca

--
Luca Ceresoli, Bootlin
Embedded Linux and Kernel engineering