[PATCH v19 20/20] x86/resctrl: Update documentation with Sub-NUMA cluster changes

[Tony Luck <tony.luck@intel.com>]

With Sub-NUMA Cluster mode enabled the scope of monitoring resources is
per-NODE instead of per-L3 cache. Suffixes of directories with "L3" in
their name refer to Sub-NUMA nodes instead of L3 cache ids.

Users should be aware that SNC mode also affects the amount of L3 cache
available for allocation within each SNC node.

Signed-off-by: Tony Luck <tony.luck@intel.com>
---
 Documentation/arch/x86/resctrl.rst | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/Documentation/arch/x86/resctrl.rst b/Documentation/arch/x86/resctrl.rst
index 627e23869bca..401f6bfb4a3c 100644
--- a/Documentation/arch/x86/resctrl.rst
+++ b/Documentation/arch/x86/resctrl.rst
@@ -375,6 +375,10 @@ When monitoring is enabled all MON groups will also contain:
 	all tasks in the group. In CTRL_MON groups these files provide
 	the sum for all tasks in the CTRL_MON group and all tasks in
 	MON groups. Please see example section for more details on usage.
+	On systems with Sub-NUMA (SNC) cluster enabled there are extra
+	directories for each node (located within the "mon_L3_XX" directory
+	for the L3 cache they occupy). These are named "mon_sub_L3_YY"
+	where "YY" is the node number.
 
 "mon_hw_id":
 	Available only with debug option. The identifier used by hardware
@@ -484,6 +488,19 @@ if non-contiguous 1s value is supported. On a system with a 20-bit mask
 each bit represents 5% of the capacity of the cache. You could partition
 the cache into four equal parts with masks: 0x1f, 0x3e0, 0x7c00, 0xf8000.
 
+Notes on Sub-NUMA Cluster mode
+==============================
+When SNC mode is enabled, Linux may load balance tasks between Sub-NUMA
+nodes much more readily than between regular NUMA nodes since the CPUs
+on Sub-NUMA nodes share the same L3 cache and the system may report
+the NUMA distance between Sub-NUMA nodes with a lower value than used
+for regular NUMA nodes.
+The top-level monitoring files in each "mon_L3_XX" directory provide
+the sum of data across all SNC nodes sharing an L3 cache instance.
+Users who bind tasks to the CPUs of a specific Sub-NUMA node can read
+the "llc_occupancy", "mbm_total_bytes", and "mbm_local_bytes" in the
+"mon_sub_L3_YY" directories to get node local data.
+
 Memory bandwidth Allocation and monitoring
 ==========================================
 
-- 
2.45.0