Re: [PATCH v2 4/5] mfd: tqmx86: make IRQ setup errors non-fatal

[Lee Jones <lee@kernel.org>]

On Mon, 17 Jun 2024, Matthias Schiffer wrote:

> GPIO IRQ setup can fail either because an invalid IRQ was passed as a
> parameter, or because the GPIO controller does not support interrupts.
> Neither is severe enough to stop the whole probe; simply disable IRQ
> support in the GPIO resource when setup fails.
> 
> Signed-off-by: Matthias Schiffer <matthias.schiffer@ew.tq-group.com>
> ---
> 
> v2: no changes (was patch 3/4)
> 
>  drivers/mfd/tqmx86.c | 7 ++++---
>  1 file changed, 4 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/mfd/tqmx86.c b/drivers/mfd/tqmx86.c
> index 5aa51ead00a28..7f9ccd83278dd 100644
> --- a/drivers/mfd/tqmx86.c
> +++ b/drivers/mfd/tqmx86.c
> @@ -259,13 +259,14 @@ static int tqmx86_probe(struct platform_device *pdev)
>  		err = tqmx86_setup_irq(dev, "GPIO", gpio_irq, io_base,
>  				       TQMX86_REG_IO_EXT_INT_GPIO_SHIFT);
>  		if (err)
> -			return err;
> +			gpio_irq = 0;
> +	}
>  
> +	if (gpio_irq)

Stacking identical if()s one after another doesn't sound very efficient.

Why not put the contents of this one inside the one above?

>  		/* Assumes the IRQ resource is first. */
>  		tqmx_gpio_resources[0].start = gpio_irq;
> -	} else {
> +	else
>  		tqmx_gpio_resources[0].flags = 0;
> -	}
>  
>  	ocores_platform_data.clock_khz = tqmx86_board_id_to_clk_rate(dev, board_id);
>  
> -- 
> TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
> Amtsgericht München, HRB 105018
> Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
> https://www.tq-group.com/
> 

-- 
Lee Jones [李琼斯]