Re: [PATCH v3 5/7] dt-bindings: iio: pressure: bmp085: Add interrupts for BMP3xx and BMP5xx devices

[Vasileios Amoiridis <vassilisamir@gmail.com>]

On Fri, Aug 23, 2024 at 06:51:55PM +0000, Biju Das wrote:
> Hi Vasileios Amoiridis,
> 
> Thanks for the patch.
> 
> > -----Original Message-----
> > From: Vasileios Amoiridis <vassilisamir@gmail.com>
> > Sent: Friday, August 23, 2024 7:17 PM
> > Subject: [PATCH v3 5/7] dt-bindings: iio: pressure: bmp085: Add interrupts for BMP3xx and BMP5xx
> > devices
> > 
> > Add interrupt options for BMP3xx and BMP5xx devices as well.
> > 
> > Signed-off-by: Vasileios Amoiridis <vassilisamir@gmail.com>
> > ---
> >  Documentation/devicetree/bindings/iio/pressure/bmp085.yaml | 7 ++++++-
> >  1 file changed, 6 insertions(+), 1 deletion(-)
> > 
> > diff --git a/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > b/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > index 6fda887ee9d4..eb1e1ab3dd18 100644
> > --- a/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > +++ b/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > @@ -48,9 +48,14 @@ properties:
> > 
> >    interrupts:
> >      description:
> > -      interrupt mapping for IRQ (BMP085 only)
> > +      interrupt mapping for IRQ. Supported in BMP085, BMP3xx, BMP5xx
> 
> Since you have updated the description. It is better to enforce the same in
> conditional schema?? So that dt binding check throws error if interrupt
> used in bmp{180,280 and bme280}.
> 
> Cheers,
> Biju
> 

Hi Biju,

Thanks for the feedback! It is true that it would be good to throw an
error in case the IRQ is used in a not supported sensor. If you could
point me to an example of another sensor implementing it, it would be
even more helpful, but I am sure I will find something :)

Cheers,
Vasilis

> >      maxItems: 1
> > 
> > +  drive-open-drain:
> > +    description:
> > +      set if the interrupt pin should be configured as open drain.
> > +      If not set, defaults to push-pull configuration.
> > +
> >  required:
> >    - compatible
> >    - vddd-supply
> > --
> > 2.25.1
>