Re: [PATCH v3 10/10] ARM: dts: ti: omap: samsung-espresso10: Add initial support for Galaxy Tab 2 10.1

[Andreas Kemnade <andreas@kemnade.info>]

Am Sat, 23 Nov 2024 17:52:58 +0000
schrieb Mithil Bavishi <bavishimithil@gmail.com>:

> > > +&i2c3 {
> > > +	touchscreen: synaptics-rmi4-i2c@20 {  
> >
> > touchscreen@20  
> Fixed, generic node names right!
> 
> > > +		avdd-supply = <&reg_touch_ldo_en>;  
> > not known in schema  
> I cannot seem to find the "vio-supply" shown in the bindings. There is
> only mention of avdd-supply and vdd-supply. I am not sure if avdd and
> vio are equivalent, hence the confusion.
> What should be the solution here?
> 
well, look at the schematics and see how it is wired ;-) 
Without schematic, it is a bit tricky. So you can look how it is used.
vdd-supply sounds like something to make the chip fully functional.
vio-supply seems to be for the io lines.  As the vendor kernel seem to
set i2c to gpio mode, so probably because the vio-supply is powered
down according to the board file you posted.
So it might be vio-supply only or vio and vdd-supply combined.
In any case document what you have seen in the vendor kernel.

> > Documentation/devicetree/bindings/input/touchscreen/touchscreen.yaml:
> > horizontal resolution of touchscreen (maximum x coordinate reported + 1)  
> 
> > So this touchscreen reports max 1278?  
> 
> Fixed it as well, 1280 and 800 respectively.
> https://github.com/Unlegacy-Android/android_kernel_ti_omap4/blob/3.4/common/arch/arm/mach-omap2/board-espresso-input.c#L264
> 
> > And these things belong below rm4-f11 according to
> > Documentation/devicetree/bindings/input/syna,rmi4.yaml  
> 
> I did not quite understand what you mean by this. I checked the bindings 
> and a few examples, there is nothing "below" rmi4-f11.
> 
this part of the binding description
patternProperties:
  "^rmi4-f1[12]@1[12]$":
    type: object
    unevaluatedProperties: false
    $ref: /schemas/input/touchscreen/touchscreen.yaml#
    description:

basically says that standard touchscreen properties are accepted below
rmi4-f11. 

In the example you have:
           rmi4-f11@11 {
                reg = <0x11>;
                touchscreen-inverted-y;
                syna,sensor-type = <2>;
            };

Regards,
Andreas