[PATCH v1 2/2] spi: gpio: Support a single always-selected device

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

The generic SPI code, the SPI GPIO driver functions support
a single always-connected device cases. The only impediment
is that board instantiation prevents that from happening.
Update spi_gpio_probe_pdata() checks to support the mentioned
hardware setup.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/spi/spi-gpio.c | 11 +++++------
 1 file changed, 5 insertions(+), 6 deletions(-)

diff --git a/drivers/spi/spi-gpio.c b/drivers/spi/spi-gpio.c
index 80a1aed42951..405deb6677c1 100644
--- a/drivers/spi/spi-gpio.c
+++ b/drivers/spi/spi-gpio.c
@@ -313,15 +313,14 @@ static int spi_gpio_probe_pdata(struct platform_device *pdev,
 	struct spi_gpio *spi_gpio = spi_controller_get_devdata(host);
 	int i;
 
-	if (!pdata || !pdata->num_chipselect)
+	if (!pdata)
 		return -ENODEV;
 
-	/*
-	 * The host needs to think there is a chipselect even if not
-	 * connected
-	 */
-	host->num_chipselect = pdata->num_chipselect ?: 1;
+	/* It's just one always-selected device, fine to continue */
+	if (!pdata->num_chipselect)
+		return 0;
 
+	host->num_chipselect = pdata->num_chipselect;
 	spi_gpio->cs_gpios = devm_kcalloc(dev, host->num_chipselect,
 					  sizeof(*spi_gpio->cs_gpios),
 					  GFP_KERNEL);
-- 
2.43.0.rc1.1336.g36b5255a03ac