[PATCH v2 2/4] ARM: dts: nxp: mxs: Adjust the imx28.dtsi L2 switch description

Lukasz Majewski
2025-03-28T13:36:16Z

The current range of 'reg' property is too small to allow full control
of the L2 switch on imx287.

As this IP block also uses ENET-MAC blocks for its operation, the address
range for it must be included as well.

Moreover, some SoC common properties (like compatible, clocks, interrupts
numbers) have been moved to this node.

Signed-off-by: Lukasz Majewski <lukma@denx.de>

---
Changes for v2:
- adding extra properties (like compatible, clocks, interupts)
---
arch/arm/boot/dts/nxp/mxs/imx28.dtsi | 8 ++++++--
1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/nxp/mxs/imx28.dtsi b/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
index bbea8b77386f..4117a5003b36 100644
--- a/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
+++ b/arch/arm/boot/dts/nxp/mxs/imx28.dtsi
@@ -1321,8 +1321,12 @@ mac1: ethernet@800f4000 {
status = "disabled";
};

- eth_switch: switch@800f8000 {
- reg = <0x800f8000 0x8000>;
+ eth_switch: switch@800f0000 {
+ compatible = "nxp,imx287-mtip-switch";
+ reg = <0x800f0000 0x20000>;
+ interrupts = <100>, <101>, <102>;
+ clocks = <&clks 57>, <&clks 57>, <&clks 64>, <&clks 35>;
+ clock-names = "ipg", "ahb", "enet_out", "ptp";
status = "disabled";
};
};
--
2.39.5