[PATCH v3 7/8] docs: iio: ad4052: Add event documentation

[Jorge Marques <jorge.marques@analog.com>]

Explain the AD4052 monitoring support by exposing as an IIO event.

Signed-off-by: Jorge Marques <jorge.marques@analog.com>
---
 Documentation/iio/ad4052.rst | 38 ++++++++++++++++++++++++++++++++++++++
 1 file changed, 38 insertions(+)

diff --git a/Documentation/iio/ad4052.rst b/Documentation/iio/ad4052.rst
index 2ad1c7712766118b03c48929d1f2b7670d5f8d41..da9c0481dfcd3b4eecd91280b7f259aa9118467c 100644
--- a/Documentation/iio/ad4052.rst
+++ b/Documentation/iio/ad4052.rst
@@ -93,3 +93,41 @@ When SPI offload is being used, additional attributes are present:
      - Description
    * - ``in_voltage_sampling_frequency``
      - Set the sampling frequency.
+
+Threshold events
+================
+
+The ADC supports a monitoring mode to raise threshold events. The driver
+supports a single interrupt for both rising and falling readings.
+
+The feature is enabled/disabled by setting ``thresh_either_en``. During monitor
+mode, the device continuously operates in autonomous mode until put back in
+configuration mode, due to this, the device returns busy until the feature is
+disabled.
+
+The following event attributes are available:
+
+.. list-table:: Event attributes
+   :header-rows: 1
+
+   * - Attribute
+     - Description
+   * - ``sampling_frequency``
+     - Frequency used in the monitoring mode, sets the device internal sample
+       rate when the mode is activated.
+   * - ``sampling_frequency_available``
+     - List of available sample rates.
+   * - ``thresh_either_en``
+     - Enable monitoring mode.
+   * - ``thresh_falling_hysteresis``
+     - Set the hysteresis value for the minimum threshold.
+   * - ``thresh_falling_value``
+     - Set the minimum threshold value.
+   * - ``thresh_rising_hysteresis``
+     - Set the hysteresis value for the maximum threshold.
+   * - ``thresh_rising_value``
+     - Set the maximum threshold value.
+
+If the interrupt ``gp0`` is not provided, the IIO events attributes are still
+present, but no IIO Event will ever be triggered. This allows to use ``gp0``
+output to trigger other resource.

-- 
2.49.0