Re: [PATCH v13 RESEND 1/4] dt-bindings: leds: add TI/National Semiconductor LP5812 LED Driver

[Nam Tran <trannamatk@gmail.com>]

On Sun, 17 Aug 2025, Rob Herring (Arm) wrote:

> On Mon, 18 Aug 2025 08:26:51 +0700, Nam Tran wrote:
> > The LP5812 is a 4x3 RGB LED driver with an autonomous animation
> > engine and time-cross-multiplexing (TCM) support for up to 12 LEDs
> > or 4 RGB LEDs. It supports both analog (256 levels) and PWM (8-bit)
> > dimming, including exponential PWM for smooth brightness control.
> > 
> > Signed-off-by: Nam Tran <trannamatk@gmail.com>
> > Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> > ---
> >  .../devicetree/bindings/leds/ti,lp5812.yaml   | 229 ++++++++++++++++++
> >  MAINTAINERS                                   |   6 +
> >  2 files changed, 235 insertions(+)
> >  create mode 100644 Documentation/devicetree/bindings/leds/ti,lp5812.yaml
> > 
> 
> My bot found errors running 'make dt_binding_check' on your patch:
> 
> yamllint warnings/errors:
> 
> dtschema/dtc warnings/errors:
> 
> 
> doc reference errors (make refcheckdocs):
> 
> See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20250818012654.143058-2-trannamatk@gmail.com
>

I do not see any errors/warnings here.

> The base for the series is generally the latest rc1. A different dependency
> should be noted in *this* patch.
> 
> If you already ran 'make dt_binding_check' and didn't see the above
> error(s), then make sure 'yamllint' is installed and dt-schema is up to
> date:
> 
> pip3 install dtschema --upgrade
> 
> Please check and re-submit after running the above command yourself. Note
> that DT_SCHEMA_FILES can be set to your schema file to speed up checking
> your schema. However, it must be unset to test all examples with your schema.

I followed the guideline and ran make dt_binding_check with the latest
dt-schema installed (pip3 install dtschema --upgrade). I don’t see any
errors or warnings for my ti,lp5812.yaml schema.

When I unset DT_SCHEMA_FILES and run the full check against all examples,
I do get errors/warnings - but they come from other existing schemas, not
from my patch, e.g.:

Documentation/devicetree/bindings/net/nfc/ti,trf7970a.yaml: properties:ti,rx-gain-reduction-db: '$ref' should not be valid under {'const': '$ref'}
Documentation/devicetree/bindings/regulator/infineon,ir38060.yaml: maintainers:0: 'Not Me.' does not match '@'
Documentation/devicetree/bindings/leds/issi,is31fl319x.yaml: properties:audio-gain-db: '$ref' should not be valid under {'const': '$ref'}
Documentation/devicetree/bindings/phy/fsl,imx8mq-usb-phy.yaml: properties:fsl,phy-pcs-tx-deemph-3p5db-attenuation-db: '$ref' should not be valid under {'const': '$ref'}

My schema (ti,lp5812.yaml) passes cleanly without any issues.

Best regards,
Nam Tran