Re: [GIT PULL] Devicetree updates for v6.19

Linus Torvalds
2025-12-05T00:25:39Z

On Wed, 3 Dec 2025 at 08:44, Rob Herring <robh@kernel.org> wrote:
>
> - Ensure all .dtbo targets are applied to a base .dtb

Bah. I pulled this and pushed it out, because it all looked fine on my
usual x86-64 targets.

But when I build on arm64 (either allmodconfig or my local config),
this results in

scripts/Makefile.dtbs:20: .dtbo is not applied to any base: rp1.dtbo
scripts/Makefile.dtbs:20: .dtbo is not applied to any base:
mt7986a-bananapi-bpi-r3-emmc.dtbo mt7986a-bananapi-bpi-r3-nand.dtbo
mt7986a-bananapi-bpi-r3-nor.dtbo mt7986a-bananapi-bpi-r3-sata.dtbo
mt7986a-bananapi-bpi-r3-sd.dtbo mt7988a-bananapi-bpi-r4-emmc.dtbo
mt7988a-bananapi-bpi-r4-sd.dtbo mt8395-radxa-nio-12l-8-hd-panel.dtbo
scripts/Makefile.dtbs:20: .dtbo is not applied to any base:
k3-am62x-phyboard-lyra-gpio-fan.dtbo k3-am62-lp-sk-nand.dtbo
k3-am642-phyboard-electra-gpio-fan.dtbo
k3-am642-phyboard-electra-pcie-usb2.dtbo
k3-am642-phyboard-electra-x27-gpio1-spi1-uart3.dtbo
k3-am642-phyboard-electra-peb-c-010.dtbo
k3-am6xx-phycore-disable-eth-phy.dtbo
k3-am6xx-phycore-disable-rtc.dtbo
k3-am6xx-phycore-disable-spi-nor.dtbo k3-am6xx-phycore-qspi-nor.dtbo
k3-j721e-evm-gesi-exp-board.dtbo

for me, and I did *not* try to dig into why. Please fix.

Linus