[PATCH v2 7/7] iio: light: opt4060: Use IIO cleanup helpers

[Kurt Borja <kuurtb@gmail.com>]

Use IIO_DEV_GUARD_ANY_MODE() cleanup helper to simplify and drop
busy-waiting code in opt4060_set_driver_state().

Signed-off-by: Kurt Borja <kuurtb@gmail.com>
---
 drivers/iio/light/opt4060.c | 52 +++++++++++++++------------------------------
 1 file changed, 17 insertions(+), 35 deletions(-)

diff --git a/drivers/iio/light/opt4060.c b/drivers/iio/light/opt4060.c
index 8cb3fa38077e..943e5963d568 100644
--- a/drivers/iio/light/opt4060.c
+++ b/drivers/iio/light/opt4060.c
@@ -302,41 +302,23 @@ static int opt4060_set_driver_state(struct iio_dev *indio_dev,
 				    bool continuous_irq)
 {
 	struct opt4060_chip *chip = iio_priv(indio_dev);
-	int ret = 0;
-any_mode_retry:
-	if (!iio_device_claim_buffer_mode(indio_dev)) {
-		/*
-		 * This one is a *bit* hacky. If we cannot claim buffer mode,
-		 * then try direct mode so that we make sure things cannot
-		 * concurrently change. And we just keep trying until we get one
-		 * of the modes...
-		 */
-		if (!iio_device_claim_direct(indio_dev))
-			goto any_mode_retry;
-		/*
-		 * This path means that we managed to claim direct mode. In
-		 * this case the buffer isn't enabled and it's okay to leave
-		 * continuous mode for sampling and/or irq.
-		 */
-		ret = opt4060_set_state_common(chip, continuous_sampling,
-					       continuous_irq);
-		iio_device_release_direct(indio_dev);
-		return ret;
-	} else {
-		/*
-		 * This path means that we managed to claim buffer mode. In
-		 * this case the buffer is enabled and irq and sampling must go
-		 * to or remain continuous, but only if the trigger is from this
-		 * device.
-		 */
-		if (!iio_trigger_validate_own_device(indio_dev->trig, indio_dev))
-			ret = opt4060_set_state_common(chip, true, true);
-		else
-			ret = opt4060_set_state_common(chip, continuous_sampling,
-						       continuous_irq);
-		iio_device_release_buffer_mode(indio_dev);
-	}
-	return ret;
+
+	IIO_DEV_GUARD_ANY_MODE(indio_dev);
+
+	/*
+	 * If we manage to claim buffer mode and we are using our own trigger,
+	 * IRQ and sampling must go to or remain continuous.
+	 */
+	if (iio_buffer_enabled(indio_dev) &&
+	    iio_trigger_validate_own_device(indio_dev->trig, indio_dev))
+		return opt4060_set_state_common(chip, true, true);
+
+	/*
+	 * This path means that we managed to claim direct mode. In this case
+	 * the buffer isn't enabled and it's okay to leave continuous mode for
+	 * sampling and/or irq.
+	 */
+	return opt4060_set_state_common(chip, continuous_sampling, continuous_irq);
 }
 
 /*

-- 
2.52.0