[PATCH net 2/2] amd-xgbe: add PCI power management for S0i3 support

[Raju Rangoju <Raju.Rangoju@amd.com>]

Add proper PCI power management operations to support modern standby
(S0i3) on AMD platforms. The existing suspend/resume implementation
did not properly handle PCI device state transitions, which prevented
the system from reaching the deepest sleep states.

The amd_pmc driver was reporting "Last suspend didn't reach deepest
state" when the XGBE driver was enabled.

The implementation follows the standard PCI PM model:

Suspend path:
- Powerdown the network interface
- Set PHY to low-power mode
- Disable bus mastering to prevent DMA activity
- Save PCI configuration state
- Disable the PCI device
- Disable wake from D3 (required for S0i3 - no Wake-on-LAN needed)
- Set device to D3hot power state

Resume path:
- Restore PCI power state to D0
- Restore PCI configuration state
- Enable the PCI device
- Re-enable bus mastering
- Re-enable device interrupts
- Clear PHY low-power mode
- Power up the network interface

Signed-off-by: Raju Rangoju <Raju.Rangoju@amd.com>
---
 drivers/net/ethernet/amd/xgbe/xgbe-pci.c | 39 ++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/drivers/net/ethernet/amd/xgbe/xgbe-pci.c b/drivers/net/ethernet/amd/xgbe/xgbe-pci.c
index 112d7697174c..8e392cccd065 100644
--- a/drivers/net/ethernet/amd/xgbe/xgbe-pci.c
+++ b/drivers/net/ethernet/amd/xgbe/xgbe-pci.c
@@ -356,15 +356,34 @@ static int xgbe_pci_suspend(struct device *dev)
 {
 	struct xgbe_prv_data *pdata = dev_get_drvdata(dev);
 	struct net_device *netdev = pdata->netdev;
+	struct pci_dev *pdev = to_pci_dev(dev);
 	int ret = 0;
 
+	if (!netdev)
+		return 0;
+
 	if (netif_running(netdev))
 		ret = xgbe_powerdown(netdev);
 
+	/* Disable all device interrupts to prevent spurious wakeups */
+	XP_IOWRITE(pdata, XP_INT_EN, 0x0);
+
+	/* Set PHY to low-power mode */
 	pdata->lpm_ctrl = XMDIO_READ(pdata, MDIO_MMD_PCS, MDIO_CTRL1);
 	pdata->lpm_ctrl |= MDIO_CTRL1_LPOWER;
 	XMDIO_WRITE(pdata, MDIO_MMD_PCS, MDIO_CTRL1, pdata->lpm_ctrl);
 
+	/* Disable bus mastering to prevent DMA activity */
+	pci_clear_master(pdev);
+
+	/* Save PCI configuration state and disable device */
+	pci_save_state(pdev);
+	pci_disable_device(pdev);
+
+	/* Disable wake from D3 - required for S0i3 deep sleep */
+	pci_wake_from_d3(pdev, false);
+	pci_set_power_state(pdev, PCI_D3hot);
+
 	return ret;
 }
 
@@ -372,13 +391,33 @@ static int xgbe_pci_resume(struct device *dev)
 {
 	struct xgbe_prv_data *pdata = dev_get_drvdata(dev);
 	struct net_device *netdev = pdata->netdev;
+	struct pci_dev *pdev = to_pci_dev(dev);
 	int ret = 0;
 
+	/* Restore PCI power state */
+	pci_set_power_state(pdev, PCI_D0);
+
+	/* Restore PCI configuration state */
+	pci_restore_state(pdev);
+
+	/* Enable PCI device */
+	ret = pci_enable_device(pdev);
+	if (ret)
+		return ret;
+
+	/* Re-enable bus mastering */
+	pci_set_master(pdev);
+
+	/* Re-enable all device interrupts */
 	XP_IOWRITE(pdata, XP_INT_EN, 0x1fffff);
 
+	/* Clear PHY low-power mode */
 	pdata->lpm_ctrl &= ~MDIO_CTRL1_LPOWER;
 	XMDIO_WRITE(pdata, MDIO_MMD_PCS, MDIO_CTRL1, pdata->lpm_ctrl);
 
+	if (!netdev)
+		return 0;
+
 	if (netif_running(netdev)) {
 		ret = xgbe_powerup(netdev);
 
-- 
2.34.1