[PATCH 1/2] dt-bindings: ufs: Document static TX Equalization settings properties

[Can Guo <can.guo@oss.qualcomm.com>]

HW design team usually provides static TX Equalization settings based on
PCB board characteristics. These settings can be passed from the device
tree to configure the TX Equalization parameters (PreShoot, DeEmphasis,
and PreCodeEn) for Host and Device across different HS gears.

Add patternProperties for txeq-settings-g[1-6] to support specifying
static TX Equalization settings.

Signed-off-by: Can Guo <can.guo@oss.qualcomm.com>
---
 Documentation/devicetree/bindings/ufs/ufs-common.yaml | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/Documentation/devicetree/bindings/ufs/ufs-common.yaml b/Documentation/devicetree/bindings/ufs/ufs-common.yaml
index ed97f5682509..bc83948fc168 100644
--- a/Documentation/devicetree/bindings/ufs/ufs-common.yaml
+++ b/Documentation/devicetree/bindings/ufs/ufs-common.yaml
@@ -105,6 +105,17 @@ properties:
       Restricts the UFS controller to rate-a or rate-b for both TX and
       RX directions.
 
+patternProperties:
+  "^txeq-settings-g[1-6]$":
+    $ref: /schemas/types.yaml#/definitions/uint32-array
+    minItems: 6
+    maxItems: 12
+    description: |
+      Static TX Equalization settings for High Speed (HS) gears.
+      The settings are specified as an array of tuples (PreShoot, DeEmphasis, PrecodeEn).
+      The array must contain these tuples in the following order:
+      Host Lane 0, [Host Lane 1], Device Lane 0, [Device Lane 1].
+
 dependencies:
   freq-table-hz: [ clocks ]
   operating-points-v2: [ clocks, clock-names ]
-- 
2.34.1