The Linux Kernel Mailing List
 help / color / mirror / Atom feed
From: Meagan Lloyd <meaganlloyd@linux.microsoft.com>
To: Ronan Dalton <ronan.dalton@alliedtelesis.co.nz>
Cc: alexandre.belloni@bootlin.com, linux-rtc@vger.kernel.org,
	linux-kernel@vger.kernel.org, Tyler Hicks <code@tyhicks.com>,
	Sasha Levin <sashal@kernel.org>,
	Meagan Lloyd <meaganlloyd@linux.microsoft.com>,
	Rodolfo Giometti <giometti@enneenne.com>,
	Chris Packham <chris.packham@alliedtelesis.co.nz>
Subject: Re: [PATCH v3] rtc: ds1307: handle oscillator stop flag for ds1337/ds1339/ds3231
Date: Mon, 11 May 2026 13:21:10 -0700	[thread overview]
Message-ID: <20260511-da8f705069778e5e3335ca43@linux.microsoft.com> (raw)
In-Reply-To: <20260508032518.3696705-2-ronan.dalton@alliedtelesis.co.nz>

On Fri, May 08, 2026 at 03:24:49PM +1200, Ronan Dalton wrote:
> Prior to commit 48458654659c ("rtc: ds1307: remove clear of oscillator
> stop flag (OSF) in probe"), the oscillator stop flag (OSF) bit was
> checked during device probe for the ds1337, ds1339, ds1341, and ds3231
> chips; if it was set, it would be cleared and a warning would be logged
> saying "SET TIME!". Since that commit, the OSF bit is no longer cleared,
> but the warning is still printed.
> 
> Directly following that commit, there was no way to get rid of this
> warning because nothing cleared the OSF bit on these chips.
> 
> The commit associated with the previous commit, 523923cfd5d6 ("rtc:
> ds1307: handle oscillator stop flag (OSF) for ds1341"), made proper use
> of the OSF when getting and setting the time in the RTC. However, the
> other RTC variants ds1337, ds1339 and ds3231 didn't have a corresponding
> change made.
> 
> Given that the OSF bit is no longer cleared at probe time when it is
> set, the remaining three chips should have the same handling as the
> ds1341 chip has for the OSF bit.
> 
> Fix the issue on the ds1337, ds1339 and ds3231 chips by applying the
> same logic as the ds1341 has to these chips.
> 
> Note that any devices brought up between the first referenced commit and
> this one may begin mistrusting the time reported by the RTC until it is
> set again, if the bit was never explicitly cleared.
> 
> Note that only the ds1339 was tested with this change, but the
> datasheets for the other chips contain essentially identical
> descriptions of the OSF bit so the same change should work.
> 
> Signed-off-by: Ronan Dalton <ronan.dalton@alliedtelesis.co.nz>
> Cc: linux-rtc@vger.kernel.org
> Cc: linux-kernel@vger.kernel.org
> Cc: Alexandre Belloni <alexandre.belloni@bootlin.com>
> Cc: Tyler Hicks <code@tyhicks.com>
> Cc: Sasha Levin <sashal@kernel.org>
> Cc: Meagan Lloyd <meaganlloyd@linux.microsoft.com>
> Cc: Rodolfo Giometti <giometti@enneenne.com>
> Cc: Chris Packham <chris.packham@alliedtelesis.co.nz>
> Fixes: 48458654659c ("rtc: ds1307: remove clear of oscillator stop flag (OSF) in probe")
> ---
> Changes in v3:
> - Remove paragraph mentioning alternative fix from commit message
> 
> Changes in v2:
> - Fix hashes of referenced commits

Reviewed-by: Meagan Lloyd <meaganlloyd@linux.microsoft.com>

> 
>  drivers/rtc/rtc-ds1307.c | 28 +++++++++++++++++-----------
>  1 file changed, 17 insertions(+), 11 deletions(-)
> 
> diff --git a/drivers/rtc/rtc-ds1307.c b/drivers/rtc/rtc-ds1307.c
> index 7205c59ff729..edf81b975dec 100644
> --- a/drivers/rtc/rtc-ds1307.c
> +++ b/drivers/rtc/rtc-ds1307.c
> @@ -269,6 +269,16 @@ static int ds1307_get_time(struct device *dev, struct rtc_time *t)
>  		if (tmp & DS1338_BIT_OSF)
>  			return -EINVAL;
>  		break;
> +	case ds_1337:
> +	case ds_1339:
> +	case ds_1341:
> +	case ds_3231:
> +		ret = regmap_read(ds1307->regmap, DS1337_REG_STATUS, &tmp);
> +		if (ret)
> +			return ret;
> +		if (tmp & DS1337_BIT_OSF)
> +			return -EINVAL;
> +		break;
>  	case ds_1340:
>  		if (tmp & DS1340_BIT_nEOSC)
>  			return -EINVAL;
> @@ -279,13 +289,6 @@ static int ds1307_get_time(struct device *dev, struct rtc_time *t)
>  		if (tmp & DS1340_BIT_OSF)
>  			return -EINVAL;
>  		break;
> -	case ds_1341:
> -		ret = regmap_read(ds1307->regmap, DS1337_REG_STATUS, &tmp);
> -		if (ret)
> -			return ret;
> -		if (tmp & DS1337_BIT_OSF)
> -			return -EINVAL;
> -		break;
>  	case ds_1388:
>  		ret = regmap_read(ds1307->regmap, DS1388_REG_FLAG, &tmp);
>  		if (ret)
> @@ -380,14 +383,17 @@ static int ds1307_set_time(struct device *dev, struct rtc_time *t)
>  		regmap_update_bits(ds1307->regmap, DS1307_REG_CONTROL,
>  				   DS1338_BIT_OSF, 0);
>  		break;
> +	case ds_1337:
> +	case ds_1339:
> +	case ds_1341:
> +	case ds_3231:
> +		regmap_update_bits(ds1307->regmap, DS1337_REG_STATUS,
> +				   DS1337_BIT_OSF, 0);
> +		break;
>  	case ds_1340:
>  		regmap_update_bits(ds1307->regmap, DS1340_REG_FLAG,
>  				   DS1340_BIT_OSF, 0);
>  		break;
> -	case ds_1341:
> -		regmap_update_bits(ds1307->regmap, DS1337_REG_STATUS,
> -				   DS1337_BIT_OSF, 0);
> -		break;
>  	case ds_1388:
>  		regmap_update_bits(ds1307->regmap, DS1388_REG_FLAG,
>  				   DS1388_BIT_OSF, 0);
> -- 
> 2.53.0

      parent reply	other threads:[~2026-05-11 20:21 UTC|newest]

Thread overview: 3+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-05-08  3:24 [PATCH v3] rtc: ds1307: handle oscillator stop flag for ds1337/ds1339/ds3231 Ronan Dalton
2026-05-08 15:00 ` Tyler Hicks
2026-05-11 20:21 ` Meagan Lloyd [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20260511-da8f705069778e5e3335ca43@linux.microsoft.com \
    --to=meaganlloyd@linux.microsoft.com \
    --cc=alexandre.belloni@bootlin.com \
    --cc=chris.packham@alliedtelesis.co.nz \
    --cc=code@tyhicks.com \
    --cc=giometti@enneenne.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-rtc@vger.kernel.org \
    --cc=ronan.dalton@alliedtelesis.co.nz \
    --cc=sashal@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox