From: Rob Herring <robh@kernel.org>
To: KobaK <kobak@nvidia.com>
Cc: Catalin Marinas <catalin.marinas@arm.com>,
Will Deacon <will@kernel.org>, Jonathan Corbet <corbet@lwn.net>,
Shuah Khan <skhan@linuxfoundation.org>,
linux-arm-kernel@lists.infradead.org, linux-doc@vger.kernel.org,
linux-kernel@vger.kernel.org, linux-kselftest@vger.kernel.org,
Fenghua Yu <fenghuay@nvidia.com>, Tushar Dave <tdave@nvidia.com>,
Kai-Heng Feng <kaihengf@nvidia.com>,
rupakr@nvidia.com, mohammedk@nvidia.com
Subject: Re: [RFC PATCH 1/3] arm64: add CPU prefetch and cache modulation sysfs interface
Date: Mon, 17 Aug 2026 17:07:50 -0500 [thread overview]
Message-ID: <20260817220750.GB2274565-robh@kernel.org> (raw)
In-Reply-To: <20260817022335.3-2-kobak@nvidia.com>
On Mon, Aug 17, 2026 at 10:23:33AM +0800, KobaK wrote:
> From: Koba Ko <kobak@nvidia.com>
>
> Performance characterization on arm64 systems sometimes needs a way to
> inspect and bracket selected implementation-defined prefetch and cache
> controls without exposing raw register contents. Add an RFC-only arm64
> cpumod interface that presents a small set of named, range-checked
> per-CPU sysfs attributes under each CPU device.
>
> Establish the Kconfig and Makefile plumbing, CPU profile detection for
> Grace and Vera from the target CPU's MIDR, register-field descriptors,
> per-CPU kobject and attribute helpers, locking, and target-CPU read/write
> callbacks. Common attributes are exposed for all supported profiles,
> while Grace- and Vera-specific fields are exposed only for the matching
> profile. Place the option at the end of the top-level Kernel Features
> menu because these implementation controls are not tied to an Arm
> architecture revision.
>
> Per-CPU cpumod sysfs state follows the CPU lifecycle. Module
> initialization populates subtrees for every online CPU while holding
> cpus_read_lock(), so initial enumeration and CPU hotplug state
> registration are serialized against concurrent topology changes. Offline
> CPUs are intentionally skipped during initial setup because target-CPU
> MIDR detection requires an IPI-capable online CPU; a later online callback
> creates their subtree.
>
> Profile detection reads MIDR through a synchronous callback on the CPU
> owning the sysfs subtree and returns nonzero only when that dispatch
> fails, so no IPI error can be hidden. After a successful read, retain
> CPUMOD_PROFILE_UNKNOWN as the unsupported-profile sentinel. Subtree
> creation skips that profile during both initial online enumeration and
> later CPUHP online callbacks without blocking module load or CPU hotplug.
> Object and sysfs setup failures remain fatal and are propagated.
>
> Keep the dynamically allocated kobject state in a private per-CPU pointer
> instead of the CPU device's generic driver-data slot. The online callback
> is idempotent when that pointer already records a subtree. The offline
> callback clears the private pointer before dropping the kobject reference,
> allowing the release callback to retain ownership of the final free.
>
> Register the dynamic CPUHP state with
> cpuhp_setup_state_nocalls_cpuslocked(). The nocalls form avoids replaying
> startup callbacks for CPUs already initialized by the explicit online
> enumeration. On init failure, release the CPU read lock, destroy all
> subtrees created so far, and return the error. Module exit removes the
> CPUHP state with the matching nocalls helper and tears down all remaining
> per-CPU state across possible CPUs.
>
> Reviewed-by: Fenghua Yu <fenghuay@nvidia.com>
> Reviewed-by: Tushar Dave <tdave@nvidia.com>
> Reviewed-by: Kai-Heng Feng <kaihengf@nvidia.com>
> Signed-off-by: Koba Ko <kobak@nvidia.com>
> ---
> arch/arm64/Kconfig | 17 +
> arch/arm64/kernel/Makefile | 1 +
> arch/arm64/kernel/arm_cpumod.c | 471 ++++++++++++++++++++++++
> arch/arm64/kernel/arm_cpumod_internal.h | 113 ++++++
> 4 files changed, 602 insertions(+)
> create mode 100644 arch/arm64/kernel/arm_cpumod.c
> create mode 100644 arch/arm64/kernel/arm_cpumod_internal.h
>
> diff --git a/arch/arm64/Kconfig b/arch/arm64/Kconfig
> index b3afe0688919b..5e4ada4884b89 100644
> --- a/arch/arm64/Kconfig
> +++ b/arch/arm64/Kconfig
> @@ -2417,6 +2417,23 @@ config ARM64_CONTPTE
> bit, for any mappings that meet the size and alignment requirements.
> This reduces TLB pressure and improves performance.
>
> +config ARM64_CPUMOD
> + tristate "Arm CPU prefetch modulation sysfs controls"
> + help
> + Expose selected CPU implementation control register fields through
> + per-CPU sysfs attributes for performance characterization.
> +
> + The exposed controls allow hardware prefetch and cache-management
> + policy fields to be inspected and adjusted on CPUs where firmware
> + permits EL1 access to the relevant implementation control registers.
> + Systems where firmware traps or blocks these writes cannot use this
> + interface.
> +
> + This interface is intended for controlled performance evaluation and
> + should not be enabled by default on production systems.
> +
> + If unsure, say N.
> +
> endmenu # "Kernel Features"
>
> menu "Boot options"
> diff --git a/arch/arm64/kernel/Makefile b/arch/arm64/kernel/Makefile
> index d2690c3ec5288..f180a52284e7d 100644
> --- a/arch/arm64/kernel/Makefile
> +++ b/arch/arm64/kernel/Makefile
> @@ -69,6 +69,7 @@ obj-$(CONFIG_VMCORE_INFO) += vmcore_info.o
> obj-$(CONFIG_ARM_SDE_INTERFACE) += sdei.o
> obj-$(CONFIG_ARM64_PTR_AUTH) += pointer_auth.o
> obj-$(CONFIG_ARM64_MPAM) += mpam.o
> +obj-$(CONFIG_ARM64_CPUMOD) += arm_cpumod.o
> obj-$(CONFIG_ARM64_MTE) += mte.o
> obj-y += vdso-wrap.o
> obj-$(CONFIG_COMPAT_VDSO) += vdso32-wrap.o
> diff --git a/arch/arm64/kernel/arm_cpumod.c b/arch/arm64/kernel/arm_cpumod.c
> new file mode 100644
> index 0000000000000..9e64f2c8e7810
> --- /dev/null
> +++ b/arch/arm64/kernel/arm_cpumod.c
> @@ -0,0 +1,471 @@
> +// SPDX-License-Identifier: GPL-2.0-only
Since the introduction of this...
> +/*
> + * Copyright (c) 2026, NVIDIA CORPORATION & AFFILIATES. All rights reserved.
> + *
> + * This program is free software; you can redistribute it and/or modify it
> + * under the terms and conditions of the GNU General Public License,
> + * version 2, as published by the Free Software Foundation.
> + *
> + * This program is distributed in the hope it will be useful, but WITHOUT
> + * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
> + * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
> + * more details.
We stopped putting license text in.
Before you go work on my comments, I'd wait for arm64 maintainers
comments. I doubt this whole thing will be accepted. In general, we
don't put in impdef interfaces to userspace.
Rob
next prev parent reply other threads:[~2026-08-17 22:07 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-17 2:23 [RFC PATCH 0/3] arm64: expose CPU prefetch and cache modulation controls KobaK
2026-08-17 2:23 ` [RFC PATCH 1/3] arm64: add CPU prefetch and cache modulation sysfs interface KobaK
2026-08-17 22:07 ` Rob Herring [this message]
2026-08-17 2:23 ` [RFC PATCH 2/3] Documentation/arch/arm64: document arm_cpumod KobaK
2026-08-17 22:03 ` Rob Herring
2026-08-17 2:23 ` [RFC PATCH 3/3] selftests: arm64: add arm_cpumod kselftest KobaK
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260817220750.GB2274565-robh@kernel.org \
--to=robh@kernel.org \
--cc=catalin.marinas@arm.com \
--cc=corbet@lwn.net \
--cc=fenghuay@nvidia.com \
--cc=kaihengf@nvidia.com \
--cc=kobak@nvidia.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-doc@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-kselftest@vger.kernel.org \
--cc=mohammedk@nvidia.com \
--cc=rupakr@nvidia.com \
--cc=skhan@linuxfoundation.org \
--cc=tdave@nvidia.com \
--cc=will@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox