Re: [PATCH 4/6] usb: xhci: Don't change the status of stalled TDs on failed Stop EP

[Mathias Nyman <mathias.nyman@linux.intel.com>]

On 10.3.2025 10.40, Michal Pecio wrote:
> When the device stalls an endpoint, current TD is assigned -EPIPE
> status and Reset Endpoint is queued. If a Stop Endpoint is pending
> at the time, it will run before Reset Endpoint and fail due to the
> stall. Its handler will change TD's status to -EPROTO before Reset
> Endpoint handler runs and initiates giveback.
> 
> Check if the stall has already been handled and don't try to do it
> again. Since xhci_handle_halted_endpoint() performs this check too,
> not overwriting td->status is the only difference.
> 
> I haven't seen this case yet, but I have seen a related one where
> the xHC has already executed Reset Endpoint, EP Context state is
> now Stopped and EP_HALTED is set. If the xHC took a bit longer to
> execute Reset Endpoint, said case would become this one.
> 
> Signed-off-by: Michal Pecio <michal.pecio@gmail.com>

Makes sense, nice improvement

Thanks
Mathias