Re: [PATCH v12 3/3] arm64: dts: qcom: talos-evk: Add support for QCS615 talos evk board

[tessolveupstream@gmail.com]

On 28-01-2026 17:29, Konrad Dybcio wrote:
> On 1/14/26 11:00 AM, Sudarshan Shetty wrote:
>> Add the device tree for the QCS615-based Talos EVK platform. The
>> platform is composed of a System-on-Module following the SMARC
>> standard, and a Carrier Board.
>>
>> The Carrier Board supports several display configurations, HDMI and
>> LVDS. Both configurations use the same base hardware, with the display
>> selection controlled by a DIP switch.
>>
>> Use a DTBO file, talos-evk-lvds-auo,g133han01.dtso, which defines an
>> overlay that disables HDMI and adds LVDS. The DTs file talos-evk
>> can describe the HDMI display configurations.
>>
>> The initial device tree includes support for:
>> - CPU and memory
>> - UART
>> - GPIOs
>> - Regulators
>> - PMIC
>> - Early console
>> - AT24MAC602 EEPROM
>> - MCP2515 SPI to CAN
>> - ADV7535 DSI-to-HDMI bridge
>> - DisplayPort interface
>> - SN65DSI84ZXHR DSI-to-LVDS bridge
>> - Wi-Fi/BT
>>
>> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
>> Signed-off-by: Sudarshan Shetty <tessolveupstream@gmail.com>
>> ---
> 
> [...]
> 
>> +	wifi_reg_en_pins_state: wifi-reg-en-pins-state {
>> +		pins = "gpio91";
>> +		function = "gpio";
>> +		drive-strength = <8>;
>> +		output-high;
>> +		bias-pull-up;
>> +	};
>> +
>> +	wlan_en_state: wlan-en-state {
>> +		pins = "gpio84";
>> +		function = "gpio";
>> +		drive-strength = <16>;
>> +		bias-pull-down;
>> +		output-low;
>> +	};
> 
> The output-low/high properties should be unnecessary since the
> drivers that requests the connected GPIOs control their state
> 
> otherwise, I think it's time to finally close in on this..
> 
> Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
>

Sure, will take care in the next patch.
Thank you.
 
> Konrad