Re: [RFC][PATCH 3/3] locking/qspinlock: Optimize for x86

[Waiman Long <longman@redhat.com>]

On 09/26/2018 07:01 AM, Peter Zijlstra wrote:
> On x86 we cannot do fetch_or with a single instruction and end up
> using a cmpxchg loop, this reduces determinism. Replace the fetch_or
> with a very tricky composite xchg8 + load.
>
> The basic idea is that we use xchg8 to test-and-set the pending bit
> (when it is a byte) and then a load to fetch the whole word. Using
> two instructions of course opens a window we previously did not have.
> In particular the ordering between pending and tail is of interrest,
> because that is where the split happens.
>
> The claim is that if we order them, it all works out just fine. There
> are two specific cases where the pending,tail state changes:
>
>  - when the 3rd lock(er) comes in and finds pending set, it'll queue
>    and set tail; since we set tail while pending is set, the ordering
>    is split is not important (and not fundamentally different form
>    fetch_or). [*]

The split can cause some changes in behavior. The 3rd locker observes
the pending bit and set tail. The split load of the 2nd locker may make
it observe the tail and backout of the pending loop. As a result, the
2nd locker will acquire the lock after the third locker in this case.
That won't happen with the original code.

I am not saying this is a problem. It is just something we should take
note on.

Cheers,
Longman