* IOAPIC problem
@ 2000-12-22 21:23 Andrei Mushinski
0 siblings, 0 replies; only message in thread
From: Andrei Mushinski @ 2000-12-22 21:23 UTC (permalink / raw)
To: linux-smp; +Cc: alan, linux-kernel
[-- Attachment #1: Type: text/plain, Size: 364 bytes --]
Dear linux-smp@vger.rutgers.edu,
As instructed by your code, I'm sending you my /var/log/dmesg file with
some IOAPIC error messages (as an attachment) I'm running a kernel
2.2.16-3smp with dual Pentium III with SuperMicro PIIIDME motherboard.
Please let me know if I can provide any additional information you might
need.
Thanks.
Andrei Mushinski.
[-- Attachment #2: dmesg --]
[-- Type: application/octet-stream, Size: 7614 bytes --]
CPU0: Intel Pentium III (Coppermine) stepping 03
calibrating APIC timer ...
..... CPU clock speed is 799.6236 MHz.
..... system bus clock speed is 133.2705 MHz.
Booting processor 1 eip 2000
Calibrating delay loop... 1599.08 BogoMIPS
Pentium-III serial number disabled.
OK.
CPU1: Intel Pentium III (Coppermine) stepping 03
Total of 2 processors activated (3194.88 BogoMIPS).
enabling symmetric IO mode... ...done.
ENABLING IO-APIC IRQs
init IO_APIC IRQs
IO-APIC (apicid-pin) 2-0, 2-20, 2-21, 2-22, 2-23, 3-0, 3-1, 3-2, 3-3, 3-4, 3-5, 3-6, 3-7, 3-8, 3-9, 3-10, 3-11, 3-12, 3-13, 3-14, 3-15, 3-16, 3-17, 3-18, 3-19, 3-20, 3-21, 3-22, 3-23 not connected.
number of MP IRQ sources: 23.
number of IO-APIC #2 registers: 24.
number of IO-APIC #3 registers: 24.
testing the IO APIC.......................
IO APIC #2......
.... register #00: 02000000
....... : physical APIC id: 02
.... register #01: 00170020
....... : max redirection entries: 0017
....... : IO APIC version: 0020
WARNING: unexpected IO-APIC, please mail
to linux-smp@vger.rutgers.edu
.... register #02: 00000000
....... : arbitration: 00
.... IRQ redirection table:
NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
00 000 00 1 0 0 0 0 0 0 00
01 000 00 0 0 0 0 0 1 1 59
02 0FF 0F 0 0 0 0 0 1 1 51
03 000 00 0 0 0 0 0 1 1 61
04 000 00 0 0 0 0 0 1 1 69
05 000 00 0 0 0 0 0 1 1 71
06 000 00 0 0 0 0 0 1 1 79
07 000 00 0 0 0 0 0 1 1 81
08 000 00 0 0 0 0 0 1 1 89
09 000 00 0 0 0 0 0 1 1 91
0a 000 00 0 0 0 0 0 1 1 99
0b 000 00 0 0 0 0 0 1 1 A1
0c 000 00 0 0 0 0 0 1 1 A9
0d 000 00 1 0 0 0 0 0 0 00
0e 000 00 0 0 0 0 0 1 1 B1
0f 000 00 0 0 0 0 0 1 1 B9
10 0FF 0F 1 1 0 1 0 1 1 C1
11 0FF 0F 1 1 0 1 0 1 1 C9
12 0FF 0F 1 1 0 1 0 1 1 D1
13 0FF 0F 1 1 0 1 0 1 1 D9
14 000 00 1 0 0 0 0 0 0 00
15 000 00 1 0 0 0 0 0 0 00
16 000 00 1 0 0 0 0 0 0 00
17 000 00 1 0 0 0 0 0 0 00
IO APIC #3......
.... register #00: 03000000
....... : physical APIC id: 03
.... register #01: 00178020
....... : max redirection entries: 0017
....... : IO APIC version: 0020
WARNING: unexpected IO-APIC, please mail
to linux-smp@vger.rutgers.edu
WARNING: unexpected IO-APIC, please mail
to linux-smp@vger.rutgers.edu
.... register #02: 0F000000
....... : arbitration: 0F
.... IRQ redirection table:
NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
00 000 00 1 0 0 0 0 0 0 00
01 000 00 1 0 0 0 0 0 0 00
02 000 00 1 0 0 0 0 0 0 00
03 000 00 1 0 0 0 0 0 0 00
04 000 00 1 0 0 0 0 0 0 00
05 000 00 1 0 0 0 0 0 0 00
06 000 00 1 0 0 0 0 0 0 00
07 000 00 1 0 0 0 0 0 0 00
08 000 00 1 0 0 0 0 0 0 00
09 000 00 1 0 0 0 0 0 0 00
0a 000 00 1 0 0 0 0 0 0 00
0b 000 00 1 0 0 0 0 0 0 00
0c 000 00 1 0 0 0 0 0 0 00
0d 000 00 1 0 0 0 0 0 0 00
0e 000 00 1 0 0 0 0 0 0 00
0f 000 00 1 0 0 0 0 0 0 00
10 000 00 1 0 0 0 0 0 0 00
11 000 00 1 0 0 0 0 0 0 00
12 000 00 1 0 0 0 0 0 0 00
13 000 00 1 0 0 0 0 0 0 00
14 000 00 1 0 0 0 0 0 0 00
15 000 00 1 0 0 0 0 0 0 00
16 000 00 1 0 0 0 0 0 0 00
17 000 00 1 0 0 0 0 0 0 00
IRQ to pin mappings:
IRQ0 -> 2
IRQ1 -> 1
IRQ3 -> 3
IRQ4 -> 4
IRQ5 -> 5
IRQ6 -> 6
IRQ7 -> 7
IRQ8 -> 8
IRQ9 -> 9
IRQ10 -> 10
IRQ11 -> 11
IRQ12 -> 12
IRQ13 -> 13
IRQ14 -> 14
IRQ15 -> 15
IRQ16 -> 16
IRQ17 -> 17
IRQ18 -> 18
IRQ19 -> 19
.................................... done.
checking TSC synchronization across CPUs: passed.
PCI: PCI BIOS revision 2.10 entry at 0xfdb91
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI->APIC IRQ transform: (B0,I31,P3) -> 19
PCI->APIC IRQ transform: (B0,I31,P1) -> 17
PCI->APIC IRQ transform: (B4,I0,P0) -> 16
PCI->APIC IRQ transform: (B1,I6,P0) -> 18
PCI->APIC IRQ transform: (B1,I8,P0) -> 16
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 524288 bhash 65536)
Initializing RT netlink socket
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with MANY_PORTS MULTIPORT SHARE_IRQ enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13)
apm: disabled - APM is not SMP safe.
Real Time Clock Driver v1.09
RAM disk driver initialized: 16 RAM disks of 4096K size
PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086, DID=2411
PCI_IDE: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
hda: Maxtor 54098U8, ATA DISK drive
hdb: IOMEGA ZIP 250 ATAPI, ATAPI FLOPPY drive
hdc: 0125, ATAPI CDROM drive
hdd: Hewlett-Packard CD-Writer Plus 9100, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: Maxtor 54098U8, 39082MB w/2048kB Cache, CHS=4982/255/63
hdc: ATAPI DVD-ROM drive, 512kB Cache
Uniform CD-ROM driver Revision: 3.10
hdd: ATAPI 32X CD-ROM CD-R/RW drive, 4096kB Cache
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.90.0 MAX_MD_DEVS=256, MAX_REAL=12
raid5: measuring checksumming speed
raid5: MMX detected, trying high-speed MMX checksum routines
pII_mmx : 1792.986 MB/sec
p5_mmx : 1872.234 MB/sec
8regs : 1374.648 MB/sec
32regs : 808.101 MB/sec
using fastest function: p5_mmx (1872.234 MB/sec)
scsi : 0 hosts.
scsi : detected total.
md.c: sizeof(mdp_super_t) = 4096
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 >
RAMDISK: Compressed image found at block 0
autodetecting RAID arrays
autorun ...
... autorun DONE.
VFS: Mounted root (ext2 filesystem).
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
eth0: OEM i82557/i82558 10/100 Ethernet, 00:30:48:21:03:90, IRQ 16.
Receiver lock-up bug exists -- enabling work-around.
Board assembly 000d80-134, Physical connectors present:
Primary interface chip None PHY #0.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x04f4518b).
Receiver lock-up workaround activated.
autodetecting RAID arrays
autorun ...
... autorun DONE.
VFS: Mounted root (ext2 filesystem) readonly.
change_root: old root has d_count=1
Trying to unmount old root ... okay
Freeing unused kernel memory: 76k freed
Adding Swap: 1052216k swap-space (priority -1)
Creative SBLive! at 0xaf80 on irq 18
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2000-12-22 21:58 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2000-12-22 21:23 IOAPIC problem Andrei Mushinski
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox