Hi,

Looks like dc2xx.c shouldn't use __devinit/__devexit
[patch attached]
or you should enable CONFIG_HOTPLUG under General Setup.

David?

The ov511 (usb) driver is the only other USB device driver
that uses __devinit/__devexit.

~Randy

josh wrote:
> 
> Kernel Version: 2.4.0-test11 - 2.4.0-prerelease
> Platform: ix86 (PIII)
> Problem Hardware: Kodac DC280, firmware 1.01
> 
> Ever since test10 or after, removing my dc280 from the usb
> bus causes khubd to crash.  I have tried both UHCI drivers
> and they produce the same effect.
> 
> dmesg, syslog, messages, and .config can be found at:
> http://mammoth.org/~skulcap/usb-problem
> 
> I have looked throug the archives and havent found anything
> like this, so I'm sorry if it has been covered already.
> 
> Thanks in advance!
-- 
_______________________________________________
|randy.dunlap_at_intel.com        503-677-5408|
|NOTE: Any views presented here are mine alone|
|& may not represent the views of my employer.|
-----------------------------------------------