Mike Panetta wrote:

> hdi: timeout waiting for DMA
> ide_dmaproc: chipset supported ide_dma_timeout func only: 14
> hdi: irq timeout: status=0x58 { DriveReady SeekComplete DataRequest }
> hdi: DMA disabled
> ide4: reset: success
> 
> I get this message on all my off board HPT366 based controller
> cards.  I am using these cards with seagate Barracuda ATA III
> Model ST320414A 20GB drives.  Are there any known issues with
> these drives and the HPT366 based controllers?  Are there any

we have a system with hpt 370's (366 driver) that we found the following
obvious bug in.  If you read the spec carefuly, it is obviously correct. 
You have to set DMA up for read vs. write.  Does this make your problems go
away?  DIff against 2.4.3


-- 
Tim Hockin
Systems Software Engineer
Sun Microsystems, Cobalt Server Appliances
thockin@sun.com