Linux version 2.4.7 (root@eiche) (gcc version 2.95.2 19991024 (release)) #4 Tue Oct 2 16:55:42 CEST 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000010000000 (usable) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) On node 0 totalpages: 65536 zone(0): 4096 pages. zone(1): 61440 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=new ro root=801 vga=0x0301 nmi_watchdog=1 Initializing CPU#0 Detected 399.321 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 796.26 BogoMIPS Memory: 255276k/262144k available (1254k kernel code, 6484k reserved, 434k data, 192k init, 0k highmem) Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) Mount-cache hash table entries: 4096 (order: 3, 32768 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) CPU: Before vendor init, caps: 0183f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0183f9ff 00000000 00000000 00000000 CPU: After generic, caps: 0183f9ff 00000000 00000000 00000000 CPU: Common caps: 0183f9ff 00000000 00000000 00000000 CPU: Intel Pentium II (Deschutes) stepping 03 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfacd0, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Using IRQ router PIIX [8086/7110] at 00:07.0 Limiting direct PCI/PCI transfers. Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 apm: BIOS version 1.2 Flags 0x07 (Driver version 1.14) Starting kswapd v1.8 VFS: Diskquotas version dquot_6.4.0 initialized Journalled Block Device driver loaded devfs: v0.107 (20010709) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x2 ACPI: APM is already active, exiting rivafb: RIVA MTRR set to ON Console: switching to colour frame buffer device 80x30 rivafb: PCI nVidia NV3 framebuffer ver 0.9.2a (RIVA-128, 8MB @ 0xE6000000) Detected PS/2 Mouse Port. pty: 256 Unix98 ptys configured block: queued sectors max/low 169493kB/56497kB, 512 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio hda: SAMSUNG SV3064D, ATA DISK drive hdc: CD-532E-B, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 59794560 sectors (30615 MB) w/434KiB Cache, CHS=3722/255/63 hdc: ATAPI 32X CD-ROM drive, 128kB Cache, DMA Uniform CD-ROM driver Revision: 3.12 Partition check: /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 SCSI subsystem driver Revision: 1.00 PCI: Found IRQ 10 for device 00:0c.0 PCI: Sharing IRQ 10 with 00:08.0 scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.13 aic7880: Ultra Wide Channel A, SCSI Id=7, 16/255 SCBs Vendor: IBM Model: DNES-309170W Rev: SA30 Type: Direct-Access ANSI SCSI revision: 03 (scsi0:A:0): 40.000MB/s transfers (20.000MHz, offset 8, 16bit) Vendor: HP Model: HP35480A Rev: T503 Type: Sequential-Access ANSI SCSI revision: 02 (scsi0:A:4): 5.000MB/s transfers (5.000MHz, offset 8) st: bufsize 32768, wrt 30720, max init. buffers 4, s/g segs 16. Attached scsi tape st0 at scsi0, channel 0, id 4, lun 0 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 17916240 512-byte hdwr sectors (9173 MB) /dev/scsi/host0/bus0/target0/lun0: p1 p2 p3 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 16384) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 192k freed Adding Swap: 205816k swap-space (priority -1) EXT3 FS 2.4-0.9.5, 30 Jul 2001 on sd(8,1), internal journal kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.5, 30 Jul 2001 on sd(8,3), internal journal EXT3-fs: mounted filesystem with ordered data mode. reiserfs: checking transaction log (device 03:01) ... Using r5 hash to sort names ReiserFS version 3.6.25 kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.5, 30 Jul 2001 on ide0(3,2), internal journal EXT3-fs: mounted filesystem with ordered data mode. reiserfs: checking transaction log (device 03:03) ... Using r5 hash to sort names ReiserFS version 3.6.25 PCI: Found IRQ 10 for device 00:08.0 PCI: Sharing IRQ 10 with 00:0c.0 3c59x.c:LK1.1.15 6 June 2001 Donald Becker and others. http://www.scyld.com/network/vortex.html See Documentation/networking/vortex.txt 00:08.0: 3Com PCI 3c905 Boomerang 100baseTx at 0xa400, 00:60:08:50:b3:45, IRQ 10 product code 4b4b rev 00.0 date 08-12-97 8K word-wide RAM 3:5 Rx:Tx split, autoselect/MII interface. MII transceiver found at address 24, status 786f. Enabling bus-master transmits and whole-frame receives. 00:08.0: scatter/gather enabled. h/w checksums disabled eth0: first available media type: MII isapnp: Scanning for PnP cards... isapnp: Card 'Adaptec AVA-1505AE' isapnp: 1 Plug & Play card detected total aha152x: BIOS test: passed, detected 1 controller(s) aha152x: resetting bus... aha152x1: vital data: rev=3, io=0x140 (0x140/0x140), irq=9, scsiid=7, reconnect=enabled, parity=enabled, synchronous=enabled, delay=1000, extended translation=disabled aha152x1: trying software interrupt, ok. scsi1 : Adaptec 152x SCSI driver; $Revision: 2.4 $ aha152x: timer expired Unable to handle kernel NULL pointer dereference at virtual address 000000fb printing eip: d2991571 *pde = 00000000 Oops: 0000 CPU: 0 EIP: 0010:[] EFLAGS: 00010082 eax: 00000000 ebx: c8149dc8 ecx: c8147000 edx: c864e800 esi: 00000000 edi: 00000086 ebp: c864e87c esp: c8149f54 ds: 0018 es: 0018 ss: 0018 Process scsi_eh_1 (pid: 318, stackpage=c8149000) Stack: 00000286 c864e800 00000000 c8147200 d299160f c864e800 c864e87c 00000286 c8147200 c01c6567 c8147200 00002003 00000000 c01c6b87 c8147200 c8148000 c8149fdc c8149fdc c864e800 c8149fe8 c8149fe8 c8147000 00000000 c01c702e Call Trace: [] [] [] [] Code: f6 80 fb 00 00 00 10 75 70 8b 4d 00 31 d2 eb 0a 89 ca 8b 82