Re: IDE DVD problem under 2.4: status=0x51 { DriveReady SeekComplete Error } (fwd)

Re: IDE DVD problem under 2.4: status=0x51 { DriveReady SeekComplete Error } (fwd)

[Igor Bukanov]

John J Tobin wrote:

> On Sun, 2001-10-14 at 20:32, Igor Bukanov wrote:
> 
>>I tried to setup my Dell Inspiron 7500 notebook (Celeron 466/512MB) with 
>>TORiSAN DVD-ROM DRD-U62 (RPC-2 drive :-( ) to watch DVD and found the 
>>following when using decss to read the encrypted vob files (other ways 
>>to access the file eventually produce the same error) under  2.4.12 
>>kernel, RedHat Linux 7.1. After I authenticated the drive and got a 
>>title key for some file, css-cat always fails on the first 2-3 attempts 
>>to read the file due to input-output error with kernel message:
>>
>>hdc: command error: status=0x51 { DriveReady SeekComplete Error }
>>hdc: command error: error=0x50
>>end_request: I/O error, dev 16:00 (hdc), sector 563008
>>
>>
> Under the IDE/ATAPI configuration stuff in the kernel configuration
> select the option "Use multi-mode by default." That may solve your
> problem.				


I already have that option on:
CONFIG_IDEDISK_MULTI_MODE=y

Should I try with this option disabled???

Here are uncommented line from my .config IDE section:
CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_IDEDISK_MULTI_MODE=y
CONFIG_BLK_DEV_IDECS=y
CONFIG_BLK_DEV_IDECD=y
CONFIG_BLK_DEV_IDEFLOPPY=y
CONFIG_BLK_DEV_IDESCSI=y
CONFIG_BLK_DEV_IDEPCI=y
CONFIG_IDEPCI_SHARE_IRQ=y
CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_BLK_DEV_ADMA=y
CONFIG_IDEDMA_PCI_AUTO=y
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_BLK_DEV_PIIX=y
CONFIG_PIIX_TUNING=y
CONFIG_IDEDMA_AUTO=y
CONFIG_BLK_DEV_IDE_MODES=y

Regards, Igor