Re: 2.4.14-pre8 Alt-SysRq-[TM] failure during lockup...

["Randy.Dunlap" <rddunlap@osdl.org>]

"Eric W. Biederman" wrote:
> 
> Summary:  I triggered a condition in 2.4.14-pre8 where SysRq triggered
> but would not print reports.  I managed to unstick the condition but
> had played to much to determine the root cause.  My guess is that
> somehow my default loglevel was messed up.  Full information is
> provided just case I did not muddy the waters too much.

Do you know what the console loglevel was when you tried
to use Alt-SysRq-M (show_mem) or Alt-SysRq-T (show tasks ==
show_state)?  (first value listed in /proc/sys/kernel/printk file)

show_mem() and show_state() don't modify the current value of
console_loglevel; they depend on the sysrq handler to do that.
That value could be too low/small.

E.g., if console_loglevel is 4, show_mem and show_state don't
show me anything on the console either, but they are added
to the log file.

[rubout]

> I then tried playing with sysrq and this is where I got worried.
> Alt-SysRq-Space gave the menu as normal.
> Alt-SysRq-M (showMem) printed just: "SysRq: Show Memory"
> Alt-SysRq-T (showTasks) printed just: "Sysrq: Show State"
> 
> Which is extremely strange the reports which should be at a higher
> loglevel were not displayed.
> 
> Then I typoed and pressed. Alt-SysRq-E (tErm) and I started getting the
> reports back.

Aye, sysrq_handle_term sets console_loglevel to 8 and leaves it there.

[rubout]

~Randy