IDE-DMA woes

[Ishan Oshadi Jayawardena <ioshadi@sltnet.lk>]

Greetings.
	I run Linux on an IBM PC300GL with Intel's
82371AB PIIX4 chipset. With DMA enabled (by doing a
hdparm -d1 /dev/hda) on the hdd, I
_sometimes_ get the following message from the kernel
after resuming from APM standby mode:

ide_dmaproc: chipset supported ide_dma_timeout func only: 14
hda: status error: status=0x59 { DriveReady SeekComplete DataRequest
Error }
hda: status error: error=0x84 { DriveStatusError BadCRC }
hda: drive not ready for command

then the drive stalls for a few seconds, and the driver
disables DMA. This behaviour doesn't seem to depend on the
kernel version (current: 2.4.14; error seen with 2.2 series also.)
The weird thing is that this is not reliably reproducable; most of
the time the system goes to apm standby (not suspend) and resumes fine.

Other (possibly relevent) boot-time messages (in order
of appearance):

IBM machine detected. Enabling interrupts during APM calls.
kernel: PIIX4: IDE controller on PCI bus 00 dev 11
PIIX4: chipset revision 1
PIIX4: not 100%% native mode: will probe irqs later
ide0: BM-DMA at 0xfff0-0xfff7, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xfff8-0xffff, BIOS settings: hdc:DMA, hdd:pio
hda: QUANTUM FIREBALL EX3.2A, ATA DISK drive
hdc: SONY CD-ROM CDU5221, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15