Greg KH wrote:
> On Thu, May 15, 2003 at 03:53:18PM -0400, David van Hoose wrote:
> 
>>Greg KH wrote:
>>
>>>On Thu, May 15, 2003 at 12:00:03AM -0400, David van Hoose wrote:
>>>
>>>
>>>>Sometime between 2.5.69-bk4 and 2.5.69-bk8, something with related to 
>>>>the USB was messed up. I get the below lines in my dmesg.
>>>>hub 2-0:0: new USB device on port 1, assigned address 2
>>>>usb 2-1: USB device not accepting new address=2 (error=-110)
>>>>hub 2-0:0: new USB device on port 1, assigned address 3
>>>>usb 2-1: USB device not accepting new address=3 (error=-110)
>>>>
>>>>The first device is my Logitech Cordless Optical Trackball.
>>>>The second device is my TI USB Graphlink.
>>>>
>>>>The Trackball still works. Not sure about the graphlink as I don't have 
>>>>the software installed yet. :-/
>>>
>>>How can the device work if the USB bus rejected it?  Also, does
>>>/proc/interrupts increment for the USB controller when you plug a device
>>>in?
>>
>>No idea. It seems to increment the usb line in /proc/interrupts.
>>I've attached a dmesg with verbose debugging.
> 
> -ENOATTACHMENT :)

Ack. Must have accidently hit cancel rather than okay. Here it is.]
By the way, this is from bk10. Same config except for usb and alsa 
debugging options.

>>>>I used the same config for bk4 as I did for bk8. It've attached my 
>>>>config for bk9 since it is the same anyway.
>>>
>>>Care to do a binary search of bk4 to bk8 to try to find the problem?
>>>Should only take you 2 reboots at most :)
>>
>>What do you want me to do? I don't know if I have the skills yet to code 
>>for the kernel, so the least I can do is test it. :-)
> 
> 
> Ok, bk4 works for you and bk8 doesn't.  So try the following:
> 	- test bk6
> 	- if bk6 fails test bk5
> 		- if bk5 fails, the problem happened between bk4 and bk5
> 		- if bk5 works, the problem happened bewtwen bk5 and bk6
> 	- if bk6 works test bk7
> 		- if bk7 fails, the problem happened between bk6 and bk7
> 		- if bk7 works, the problem happened between bk7 and bk8
> 
> And let us know what the result is, please.

Will do that tonight.

Thanks,
David