Re: system clock speed too high?

[Andreas Haumer <andreas@xss.co.at>]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi!

I have some more information

6.) Kernel 2.4.19-ac4 (ACPI compiled as modules)
    a) no special kernel commandline option
       -> System does boot, fusion MTP driver finds the controller
       -> time runs 2.5 times too fast

    b) boot with "acpi=off"
       -> Same as 6a)

    c) boot with "acpi=off notsc"
       -> Same as 6a)

I tried also the following BIOS settings, but without
improving the situation:

*) Hyperthreading "disabled"
*) MPS 1.4 Support "disabled"
*) BIOS Update "disabled"
*) Plug & Play "yes" (this makes it even worse: linux crashes
               eventually as it gets confused by IRQ setting)

- - andreas

- --
Andreas Haumer                     | mailto:andreas@xss.co.at
*x Software + Systeme              | http://www.xss.co.at/
Karmarschgasse 51/2/20             | Tel: +43-1-6060114-0
A-1100 Vienna, Austria             | Fax: +43-1-6060114-71
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQE+3I2/xJmyeGcXPhERAjXOAKCc7lD6Y+oYUyvNtqVT/dj+HBpP+wCfcWI4
/Pfay3OP/7/XPxpIbBAE9X4=
=cIUN
-----END PGP SIGNATURE-----