2.6.0-test9-mm3 and enanched IDE mode on p4c800 deluxe

2.6.0-test9-mm3 and enanched IDE mode on p4c800 deluxe

[Catani, Antonio]

Hi list, i can non know if my request is in topic or not.
I have p4c800 deluxe from asus, and works fine with mm3 patch, but I'v
notice a little beat strange thing in bios of this mobo there is a
option for setting ide interface in enanched mode, so if I set on the
kernel start and in dmesg I see ICH-5 100% native mode but after mount
root I get many of disabled irq 169 and the system hangs so to reset
hardware.

In compatible mode the system works fine, but I see in dmesg ICH-5 not
100% native mode, will probe irq later, someone can explain me the
difference about two behavior?

Many thanks



=== Start-of Internet E-mail Confidentiality Footer ===

L'uso non autorizzato di questo messaggio o dei suoi allegati e' vietato e potrebbe costituire reato.
Se ha ricevuto per errore questo messaggio, La preghiamo di informarci e di distruggerlo immediatamente coi suoi allegati.
Le dichiarazioni contenute in questo messaggio o nei suoi allegati non impegnano SECETI S.p.A. nei confronti del destinatario o di terzi.
SECETI S.p.A. non si assume alcuna responsabilita' per eventuali intercettazioni, modifiche o danneggiamenti del presente messaggio.
Any unauthorized use of this e-mail or any of its attachments is prohibited and could constitute an offence.
If you are not the intended addressee please advise immediately the sender and destroy the message and its attachments.
The contents of this message shall be understood as neither given nor endorsed by SECETI S.p.A.
SECETI S.p.A. does not accept liability for corruption, interception or amendment, if any, or the consequences thereof.

Re: 2.6.0-test9-mm3 and enanched IDE mode on p4c800 deluxe

[Jeff Garzik]

Catani, Antonio wrote:
> Hi list, i can non know if my request is in topic or not.
> I have p4c800 deluxe from asus, and works fine with mm3 patch, but I'v
> notice a little beat strange thing in bios of this mobo there is a
> option for setting ide interface in enanched mode, so if I set on the
> kernel start and in dmesg I see ICH-5 100% native mode but after mount
> root I get many of disabled irq 169 and the system hangs so to reset
> hardware.
> 
> In compatible mode the system works fine, but I see in dmesg ICH-5 not
> 100% native mode, will probe irq later, someone can explain me the
> difference about two behavior?


Are you using Serial ATA?

	Jeff