Re: 2.6-test11 framebuffer Matrox

[Michael Hunold <hunold@convergence.de>]

Hello Steffen,

> My Matrox-framebuffer is not working properly. Build direct into the
> kernel, the monitor will be black with some stripes at startup, just the
> reset button works.
> Build as a modules, the same happens if I load the module.

Hmm, I just tested with the 2.6.0 release and my both cards are working 
properly now. The only thing is a huge white box around the penguin logo.

Here is "lspci -v" of the cards I tested:

00:0a.0 VGA compatible controller: Matrox Graphics, Inc. MGA G200 (rev 
01) (prog-if 00 [VGA])
	Subsystem: Matrox Graphics, Inc. Millennium G200 SD
	Flags: bus master, medium devsel, latency 64, IRQ 11
	Memory at dd000000 (32-bit, prefetchable) [size=16M]
	Memory at dfffc000 (32-bit, non-prefetchable) [size=16K]
	Memory at df000000 (32-bit, non-prefetchable) [size=8M]
	Expansion ROM at dffe0000 [disabled] [size=64K]
	Capabilities: [dc] Power Management version 1

01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400 AGP 
(rev 03) (prog-if 00 [VGA])
	Subsystem: Giga-byte Technology GA-G400
	Flags: bus master, medium devsel, latency 64, IRQ 11
	Memory at dc000000 (32-bit, prefetchable) [size=32M]
	Memory at dfafc000 (32-bit, non-prefetchable) [size=16K]
	Memory at df000000 (32-bit, non-prefetchable) [size=8M]
	Expansion ROM at dfae0000 [disabled] [size=64K]
	Capabilities: [dc] Power Management version 2
	Capabilities: [f0] AGP version 2.0

> Steffen

CU
Michael.