Re: [PATCH v8] i2c: designware: fix master is holding SCL low while ENABLE bit is disabled

[Jarkko Nikula <jarkko.nikula@linux.intel.com>]

On 9/10/24 9:13 AM, Kimriver Liu wrote:
> It was observed issuing ABORT bit(IC_ENABLE[1]) will not work when
> IC_ENABLE is already disabled.
> 
> Check if ENABLE bit(IC_ENABLE[0]) is disabled when the master is
> holding SCL low. If ENABLE bit is disabled, the software need
> enable it before trying to issue ABORT bit. otherwise,
> the controller ignores any write to ABORT bit.
> 
> Signed-off-by: Kimriver Liu <kimriver.liu@siengine.com>
> Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
> 
> ---
> V7->V8:
> 	1.calculate this delay based on the actual speed in use
> 	  fsleep(DIV_ROUND_CLOSEST_ULL(10 * MICRO, t->bus_freq_hz))
> 	2. add Reviewed-by: Mika Westerberg<mika.westerberg@linux.intel.com>
> V6->V7:
> 	1. add Subject versioning [PATCH v7]
> 	2. change fsleep(25) to usleep_range(25, 250)
> 	3. Add macro definition DW_iC_ENABLE_ENABLE to fix compile errors
> 	  | Reported-by: kernel test robot <lkp@intel.com>
> 	  | Closes:https://lore.kernel.org/oe-kbuild-all/202409082011.9JF6aYsk-lkp@intel.com/
> 	4. base: https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=master
> V5->V6: restore i2c_dw_is_master_idling() function checking
> V4->V5: delete master idling checking
> V3->V4:
> 	1. update commit messages and add patch version and changelog
> 	2. move print the error message in i2c_dw_xfer
> V2->V3: change (!enable) to (!(enable & DW_IC_ENABLE_ENABLE))
> V1->V2: used standard words in function names and addressed review comments
> 
> link to V1:
> https://lore.kernel.org/lkml/20240904064224.2394-1-kimriver.liu@siengine.com/
> ---
>   drivers/i2c/busses/i2c-designware-common.c | 13 +++++++++++++
>   drivers/i2c/busses/i2c-designware-core.h   |  1 +
>   drivers/i2c/busses/i2c-designware-master.c | 22 ++++++++++++++++++++++
>   3 files changed, 36 insertions(+)
> 
Acked-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>