From: Sid Boyce <sboyce@blueyonder.co.uk>
To: linux-kernel@vger.kernel.org
Subject: Re: 2.6.5-rc3-mm4
Date: Sat, 03 Apr 2004 12:08:13 +0100 [thread overview]
Message-ID: <406E9B1D.7070201@blueyonder.co.uk> (raw)
In-Reply-To: <406CD984.2010200@blueyonder.co.uk>
Sid Boyce wrote:
> My x86_64 Acer 1501LCe laptop problem persists, it freezes at the same
> point with the HD light on solid. Boot proceeds normally up to "found
> reiserfs format "3.6" with standard journal".
> Regards
> Sid.
>
Tried using netconsole, but no network traffic, suppose because the
network is not yet up, so I can't get a call trace captured with ...
netconsole=6665@192.168.10.5/eth0,6666@192.168.10.1/00:40:95:30:db:5b
From SysRq-B
============
Uniform CD-ROM driver Revision: 3.20
mice: PS/2 mouse device common for all mice
input: PC Speaker
i8042.c: Detected active multiplexing controller, rev 1.1.
serio: i8042 AUX0 port at 0x60,0x64 irq 12
serio: i8042 AUX1 port at 0x60,0x64 irq 12
serio: i8042 AUX2 port at 0x60,0x64 irq 12
serio: i8042 AUX3 port at 0x60,0x64 irq 12
Synaptics Touchpad, model: 1
Firmware: 5.8
180 degree mounted touchpad
Sensor: 18
new absolute packet format
Touchpad has extended capability bits
-> 4 multi-buttons, i.e besides standard buttons
-> multifinger detection
-> palm detection
input: SynPS/2 Synaptics TouchPad on isa0060/serio4
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
NET: Registered protocol family 2
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 32768)
Net: Registered protocol family 1
ACPI: (supports S0 S3 S4 S5)
found reiserfs format "3.6" with standard journal
SysRq: Show Regs
Pid: 0, comm: swapper Not tainted 2.6.5-rc3-mm4
RIP: 0010:[<ffffffff8010e660>] <ffffffff80103660>{default_idle+32}
RSP: 0000:ffffffff8050ffc8 EFLAGS: 00000246
RAX: 0000000000000000 RBX: ffffffff8010e640 RCX: ffffffff8040ca40
RDX: 0000000000000000 RSI: 00000000ffffffff RDI: 000001001fe86040
RBP: 0000000000000000 R08: ffffffff8050e000 R09: 00000000ffffffff
R10: 0000000000000000 R11: 00000000ad55ad55 R12: 0000000000000000
R13: 0000000000000000 R14: 0000000000000000 R15: 0000000000000000
FS: 0000000000000000(0000) GS:ffffffff80507800(0000) knlGS:0000000000000000
CS: 0010 DS: 0018 ES: 0018 CR0: 000000008005003b
CR2: 0000000000000000 CR3: 0000000000101000 CR4: 00000000000006e0
Call Trace:<ffffffff8010f5da>{cpu_idle+26}
<ffffffff805117ad>{start_kernel+509}
<ffffffff805110e5>{__init_begin+229}
Regards
Sid.
--
Sid Boyce .... Hamradio G3VBV and keen Flyer
Linux Only Shop.
next prev parent reply other threads:[~2004-04-03 11:06 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-04-02 3:09 2.6.5-rc3-mm4 Sid Boyce
2004-04-03 11:08 ` Sid Boyce [this message]
2004-04-04 22:32 ` 2.6.5 x86_64 still broken - was 2.6.5-rc3-mm4 Sid Boyce
-- strict thread matches above, loose matches on Subject: below --
2004-04-04 1:15 2.6.5-rc3-mm4 Paul Blazejowski
2004-04-04 23:34 ` 2.6.5-rc3-mm4 Trond Myklebust
2004-04-05 1:25 ` 2.6.5-rc3-mm4 Paul Blazejowski
2004-04-01 10:05 2.6.5-rc3-mm4 Andrew Morton
2004-04-01 12:02 ` 2.6.5-rc3-mm4 Marc-Christian Petersen
2004-04-01 15:16 ` 2.6.5-rc3-mm4 Greg KH
2004-04-01 15:32 ` 2.6.5-rc3-mm4 Marc-Christian Petersen
2004-04-01 14:12 ` 2.6.5-rc3-mm4 Norberto Bensa
2004-04-02 1:35 ` 2.6.5-rc3-mm4 Joshua Kwan
2004-04-02 2:09 ` 2.6.5-rc3-mm4 Norberto Bensa
2004-04-02 19:04 ` 2.6.5-rc3-mm4 markw
2004-04-02 19:56 ` 2.6.5-rc3-mm4 Andrew Morton
2004-04-02 20:46 ` 2.6.5-rc3-mm4 markw
2004-04-02 23:43 ` 2.6.5-rc3-mm4 Nick Piggin
2004-04-03 0:10 ` 2.6.5-rc3-mm4 Mark Wong
2004-04-03 0:12 ` 2.6.5-rc3-mm4 Nick Piggin
2004-04-06 15:20 ` 2.6.5-rc3-mm4 markw
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=406E9B1D.7070201@blueyonder.co.uk \
--to=sboyce@blueyonder.co.uk \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox