Re: 2.6.7-rc2-mm1

[Sid Boyce <sboyce@blueyonder.co.uk>]

Reversing Bjorn's ACPI patch fixed it.
Regards
Sid.

Sid Boyce wrote:

> Andrew Morton wrote:
>
>> Sid Boyce <sboyce@blueyonder.co.uk> wrote:
>>  
>>
>>> As with 2.6.7-rc1-mm1, I'm seeing the same problem on 2.6.7-rc2-mm1. 
>>> 2.6.7-rc1 and 2.6.7-rc2 are OK. It hangs needing a hard reset 
>>> setting up /dev/pts, with console=ttyS1 .... same as before. SuSE 
>>> 9.1 on A7N8X-E nforce2 chipset.
>>>   
>>
>>
>> Works OK here.  Is it the `console=ttyS1' which is causing the hang?  If
>> not, what?  Try removing boot options, stripping config options, etc.
>>
>>
>>
>>  
>>
> Bjorn Helgaas also wrote:
>
> Can you send me the dmesg from a 2.6.7-rc1 boot (i.e., the one that
> works)?  I changed some ACPI PCI IRQ routing stuff in -mm1, and I
> want to make sure that's not what's causing your lockup.
> ===================================================================
>
> 2.6.7-rc2-mm2 also had the same problem, I rebooted with "acpi=off" 
> and it's OK.
> .config settings ---
> # Power management options (ACPI, APM)
> # ACPI (Advanced Configuration and Power Interface) Support
> CONFIG_ACPI=y
> CONFIG_ACPI_BOOT=y
> CONFIG_ACPI_INTERPRETER=y
> # CONFIG_ACPI_SLEEP is not set
> # CONFIG_ACPI_AC is not set
> # CONFIG_ACPI_BATTERY is not set
> # CONFIG_ACPI_BUTTON is not set
> CONFIG_ACPI_FAN=y
> CONFIG_ACPI_PROCESSOR=y
> CONFIG_ACPI_THERMAL=y
> # CONFIG_ACPI_ASUS is not set
> # CONFIG_ACPI_TOSHIBA is not set
> CONFIG_ACPI_DEBUG=y
> CONFIG_ACPI_BUS=y
> CONFIG_ACPI_EC=y
> CONFIG_ACPI_POWER=y
> CONFIG_ACPI_PCI=y
> CONFIG_ACPI_SYSTEM=y
> # CONFIG_X86_ACPI_CPUFREQ is not set
> CONFIG_SERIAL_8250_ACPI=y
>
> Regards
> Sid.
>


-- 
Sid Boyce .... Hamradio G3VBV and keen Flyer
Linux Only Shop.