sd_mod problems with 2.6.7rc2

sd_mod problems with 2.6.7rc2

[Roland Lezuo]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hello,

this nasty scsi / usb_storage bug is still around.

usb 1-4: new high speed USB device using address 2
scsi0 : SCSI emulation for USB Mass Storage devices
~  Vendor: Generic   Model:                   Rev:
~  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0,  type 0
USB Mass Storage device found at 2

here I modprobed sd_mod and wait 30 sec till modprobe returned to the
prompt.

SCSI device sda: 251904 512-byte hdwr sectors (129 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
scsi: Device offlined - not ready after error recovery: host 0 channel 0
id 0 lun 0
sda: asking for cache data failed
sda: assuming drive cache: write through
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0

I can't access /dev/sda, and there is no /dev/sda4 entry (using devfs)
as there should be. I'll provide any infos you need...


regards
Roland Lezuo

P.S.: please CC me personally
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFAwJWM5qlVDPzJ7R4RAjWWAJ9Z4eCCI+aien2OMBVfemwYKFj4nwCggVFo
Ork7UMtjXMsXlYAYN9liKgs=
=5uue
-----END PGP SIGNATURE-----