2.6.7-rc3-mm1 and advansys driver failes to mount

2.6.7-rc3-mm1 and advansys driver failes to mount

[Pieter Ennes]

Hi,

I'm having troubles getting the advansys driver to work in
2.6.7-rc3-mm1. dmesg output seems OK, but when mounting
no filesystem can be found on the partitions.

2.6.7-rc3 is fine. I noticed a few changes in drivers/scsi/advansys.c,
but i'm not much of a hacker to sort it out...

scsi1 : AdvanSys SCSI 3.3GJ: PCI Ultra-Wide: PCIMEM 
0xE0BE0000-0xE0BE003F, IRQ 0x13
   Vendor: SEAGATE   Model: ST39173W          Rev: 6244
   Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sdb: 17783240 512-byte hdwr sectors (9105 MB)
SCSI device sdb: drive cache: write back
  /dev/scsi/host1/bus0/target2/lun0: unknown partition table
Attached scsi disk sdb at scsi1, channel 0, id 2, lun 0
Attached scsi generic sg1 at scsi1, channel 0, id 2, lun 0,  type 0
   Vendor: IBM       Model: IC35L036UWD210-0  Rev: S5CQ
   Type:   Direct-Access                      ANSI SCSI revision: 03
SCSI device sdc: 71687340 512-byte hdwr sectors (36704 MB)
SCSI device sdc: drive cache: write back
  /dev/scsi/host1/bus0/target6/lun0: unknown partition table
Attached scsi disk sdc at scsi1, channel 0, id 6, lun 0
Attached scsi generic sg2 at scsi1, channel 0, id 6, lun 0,  type 0

Cheers,
-- 
  - Pieter