Re: 2.6.7-mm2

Angelo Dell'Aera
2004-06-24T11:43:46Z

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Thu, 24 Jun 2004 03:33:21 -0700
Andrew Morton <akpm@osdl.org> wrote:

>OK, ACPI seems to have progressed in a non-forward direction here.
>
>If anyone has weird problems, please do a `patch -p1 -R' of
>
>ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.7/2.6.7-mm2/broken-out/bk-acpi.patch
>
>USB doesn't come up:
>
>usb 2-1: control timeout on ep0out
>uhci_hcd 0000:00:1d.0: Unlink after no-IRQ? Different ACPI or APIC settings may help.
>usb 2-1: control timeout on ep0out
>usb 2-1: device not accepting address 2, error -110
>usb 2-1: new low speed USB device using address 3
>usb 2-1: control timeout on ep0out
>usb 2-1: control timeout on ep0out
>usb 2-1: device not accepting address 3, error -110
>usb 2-2: new full speed USB device using address 4
>usb 2-2: control timeout on ep0out
>usb 2-2: control timeout on ep0out
>usb 2-2: device not accepting address 4, error -110
>usb 2-2: new full speed USB device using address 5
>usb 2-2: control timeout on ep0out
>usb 2-2: control timeout on ep0out
>usb 2-2: device not accepting address 5, error -110

Here no problems at all. ACPI works quite good and I did few tests
for USB which show no particular problem.

buffer@mintaka:~$ cat /proc/cpuinfo | grep "model name"
model name : mobile AMD Athlon(tm) XP 2000+

At boot time...

usbcore: registered new driver usbfs
usbcore: registered new driver hub
ACPI: PCI interrupt 0000:00:02.0[A] -> GSI 10 (level, low) -> IRQ 10
ohci_hcd 0000:00:02.0: ALi Corporation USB 1.1 Controller
ohci_hcd 0000:00:02.0: irq 10, pci mem dfc1c000
ohci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 4 ports detected

While playing with a 4 port HUB and a digital camera...

ohci_hcd 0000:00:02.0: remote wakeup
usb 1-2: new full speed USB device using address 2
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Fujifilm Model: FinePix 1400Zoom Rev: 1000
Jun 24 13:21:08 mintaka kernel:
Type: Direct-Access ANSI SCSI revision: 02
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
scsi.agent[1690]: disk at /devices/pci0000:00/0000:00:02.0/usb1/1-2/1-2:1.0/host0/0:0:0:0
SCSI device sda: 16000 512-byte hdwr sectors (8 MB)
sda: assuming Write Enabled
sda: sda1
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
usb 1-2: USB disconnect, address 2
ohci_hcd 0000:00:02.0: remote wakeup
usb 1-2: new full speed USB device using address 3
hub 1-2:1.0: USB hub found
hub 1-2:1.0: 4 ports detected
usb 1-2.2: new full speed USB device using address 4
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: Fujifilm Model: FinePix 1400Zoom Rev: 1000
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 16000 512-byte hdwr sectors (8 MB)
sda: assuming Write Enabled
sda: sda1
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
scsi.agent[1908]: disk at /devices/pci0000:00/0000:00:02.0/usb1/1-2/1-2.2/1-2.2:1.0/host1/1:0:0:0
usb 1-2.2: USB disconnect, address 4
usb 1-2: USB disconnect, address 3

Regards.

- --

Angelo Dell'Aera 'buffer'
Antifork Research, Inc. http://buffer.antifork.org

PGP information in e-mail header

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFA2r5opONIzxnBXKIRAvHWAKCbyh6g2BhcStWNSSP01IjKbGskKQCeOYc+
n/njVG7fSWhY6BeuaCxBIOw=
=mX3F
-----END PGP SIGNATURE-----