Re: [PATCH 0/3] Add support for the RK356x variant of the Inno CSI DPHY

Michael Riesch
2022-07-21T09:38:46Z

Hi all,

On 7/20/22 11:15, Michael Riesch wrote:
> Hi all,
>
> This series adds support for the variant of the Innosilicon MIPI CSI DPHY that
> can be found in Rockchip RK356x SoCs.
>
> Please note that only the basic operating mode is supported, in which all four
> CSI lanes are controlled by the Rockchip ISP. Split lane operation (e.g., two
> lanes to ISP and two lanes to VICAP) is not supported.
>
> This has been tested on a Radxa ROCK3 Model A board together with an IMX219
> camera sensor and a patched version of the rkisp1 driver (with support for the
> RK356x variant V2.1 added in a very crude way).

If someone would like to test the patches, I pushed the hacks required
to bring up the RK3568 ISP to

https://github.com/mriesch-wv/linux/commits/feature/isp2

The following commands are required to set up streaming for my IMX219
module (Raspberry Pi Camera V2.1):

media-ctl -d "platform:rkisp1" --set-v4l2 '"rkisp1_isp":0
[fmt:SRGGB10_1X10/3280x2464 crop: (0,0)/3200x2400]'

media-ctl -d "platform:rkisp1" --set-v4l2 '"rkisp1_isp":2
[fmt:YUYV8_2X8/3200x2400 crop: (0,0)/3200x2400]'

media-ctl -d "platform:rkisp1" --set-v4l2 '"rkisp1_resizer_mainpath":0
[fmt:YUYV8_2X8/3200x2400 crop: (0,0)/3200x2400]'

media-ctl -d "platform:rkisp1" --set-v4l2 '"rkisp1_resizer_mainpath":1
[fmt:YUYV8_2X8/3200x2400]'

media-ctl -d "platform:rkisp1" --set-v4l2 '"rkisp1_resizer_selfpath":0
[fmt:YUYV8_2X8/3200x2400]'

media-ctl -d "platform:rkisp1" --set-v4l2 '"rkisp1_resizer_selfpath":1
[fmt:YUYV8_2X8/800x600]'

v4l2-ctl -z "platform:rkisp1" -d "rkisp1_mainpath" -v
"width=3200,height=2400"

(adjust to your camera module as required). After that, I can stream
with, e.g.,

gst-launch-1.0 v4l2src ! video/x-raw,width=3200,height=2400 ! waylandsink

The image quality is horrid, of course (I think the ISP is not even
debayering the sensor data), but one can recognize the objects before
the camera and it can be proved that the CSI DPHY works.

Best regards,
Michael

>
> Looking forward to your comments!
>
> Best regards,
> Michael
>
> Michael Riesch (3):
> dt-bindings: phy: add compatible for rk356x to rockchip-inno-csi-dphy
> phy: rockchip: add support for the rk356x variant to
> rockchip-inno-csidphy
> arm64: dts: rockchip: add csi dphy node to rk356x
>
> .../bindings/phy/rockchip-inno-csi-dphy.yaml | 1 +
> arch/arm64/boot/dts/rockchip/rk356x.dtsi | 12 ++++++++++
> .../phy/rockchip/phy-rockchip-inno-csidphy.c | 24 +++++++++++++++++++
> 3 files changed, 37 insertions(+)
>